Search Results
Showing results for test-for
Safety and compliance information for Ring Intercom (5F99F2)
...s intercom electrical wiring, you must turn off the existing intercom’s power source at your home’s circuit breaker or fuse and test that the power is off BEFORE removing the existing intercom, installing the Ring Intercom, or touching electrical wires. Failure to turn off...
Safety and compliance information for Battery Video Doorbell Pro
...off the existing doorbell’s power source at your home’s circuit breaker or fuse and test that the power is off BEFORE removing the existing doorbell, installing the Ring Battery Doorbell Pro, or touching electrical wires. Failure to...
Charging your Ring Security Camera batteries
...to power back on : It can take up to 60 seconds. Battery not charging If you notice your Ring device’s battery is not charging, try the following: Test your outlet to make sure it's working properly by plugging in another device. Try a different charging cable. Learn more about Troubleshooting...
Understanding your Ring Intercom device's LED light patterns
...has failed, miscellaneous reason Light flashing red/blue Ring Intercom device is in testing mode Green light fading in and out Call detection testing, call detected Solid blue light Firmware...
Safety and compliance information for Ring Video Doorbell Wired
...More than one disconnect switch may be re- quired to turn off the equipment before ser- vicing. To test whether you have successfully de-energised your existing doorbell’s power source, press your doorbell several times to confirm that the power is...
Safety and compliance information for Ring Wired Video Doorbell (2nd Gen)
...Gen) to your home's doorbell electrical wiring, you must turn off the existing doorbell's power source at your home's circuit breaker or fuse and test that the power is off BEFORE removing the existing doorbell, installing the Wired Doorbell (2nd Gen), or touching electrical wires. Failure to turn...
Safety and compliance information for Ring Battery Video Doorbell Plus
...in FIRE, ELECTRIC SHOCK, or OTHER INJURY or DAMAGE. More than one disconnect switch may be required to turn off the equipment before servicing. To test whether you have successfully de-energised your existing doorbell’s power source, press your doorbell several times to confirm that the power is...
Safety and compliance information for Access Control Unit V2
...device elec- trical wiring, you must turn off the existing access control device’s power source at your building’s circuit breaker or fuse and test that the power is off BEFORE removing the existing access control device, installing the Access Control Unit, or touching electrical wires. Failure...
Safety and compliance information for Ring Floodlight Cam Wired Plus
...You must disconnect the power source at the home’s circuit breaker or consumer unit and test that the power is off BEFORE removing an existing light fixture, installing the device, or touching electrical wires. It is extremely important to...
Installing your Contact Sensor (2nd Generation)
...from identifying your security measures. Steel doors and aluminium door frames may occasionally cause interference for the Contact Sensor. Test the Sensor on your door or window to determine if there are any issues. Still need more help? Check out this video...