Search Results
Showing results for i-green
Troubleshooting your Ring Alarm Glass Break Sensor
...you identify if it’s working well, or if there's something wrong. When you press the setup button on the front of the device, you may see: Three green flashes, a pause, followed by three green flashes. That means it is ready to connect to your Base Station. One green flash. It is connected and...
Outdoor Contact Sensor communications test
...When you complete the Outdoor Contact Sensor communications test, if the LED next to the setup button turns green, your test was successful. If the LED turns red, the device can't communicate with the alarm system. If the communications test didn’t pass, we...
Installing your Contact Sensor (2nd Generation)
...When you open the door or window, you see the LED flash green (and hear the chirp tone, if enabled). There needs to be 1.25 cm of space around the sensor so you can slide it open to replace the batteries. You...
Understanding Chime light patterns
...display light patterns according to the status of the device. Activity Flashing Light Pattern Flashing Light Image Boot up Solid green circle light Setup mode Green circle light flashing Firmware update in progress Alternating blue and green circle light Factory reset Alternating blue and green...
Outdoor Siren communications test
...of these steps, run the communications test again by tapping the Test button in the Outdoor Siren’s battery compartment. If the LED turns solid green, your test was successful. If the LED turns solid red still, we recommend that you select a new installation location to ensure the device can...
Troubleshooting your Ring Alarm Panic Button
...If it blinks green three times, it is ready to connect to the Base Station. If it blinks green once, it is connected and communicating with your Base Station. If it blinks red once, it is unable to communicate with the Base Station. Still...
Charging your Ring Intercom device battery
...charge, depending on whether the USB cable is plugged into a USB port or a wall outlet. Note : While your battery is charging, both the red and green lights will light up. Your battery is fully charged when the light on the battery shines a solid green. Slide the fully charged battery back into...
Installing and using Ring Alarm Glass Break Sensor
...Inclusion StartedGreen LED blink quickly, repeated after a brief pause Classic Inclusion Timed-OutAlternate red and green a few times Inclusion Successful (Authenticated S2)Green LED on solid Inclusion Not Successful (Self-Destruct)Red LED on solid 5 Z-Wave Command Classes Command...
Installing your Stick Up Cam Battery (2nd Gen)
...using the provided orange cable or any other micro USB cable you have handy. While charging, your battery displays two coloured lights, a solid green and an amber light. Charge the battery until only the green light remains lit. Remove the battery cover on your Stick Up Cam by twisting it...
Understanding Floodlight Cam and Spotlight Cam light patterns
...Ring’s servers or the internet. Learn more about fixing device setup issues here. Green light turning on for one second, then off Setup successful Green light on for five seconds then turning off Speaker enabled and camera recording Solid blue light Siren is activated Red light turning...