Troubleshooting your Ring Alarm Panic Button

Having issues with your Ring Alarm Panic Button? Follow these troubleshooting steps to help resolve them.

If your Panic Button won’t connect

• Move your Panic Button closer to your Alarm Base Station.
• Add a

  Range Extender

  between your Panic Button and the Base Station. The Range Extender helps extend and expand the Base Station’s Z-Wave network, allowing for greater range and signal strength for all compatible devices at your location.
• Open the cover (see photo below) and briefly press the button on the front of the device (do not hold it down because this could trigger the panic alarm).
  • If it blinks green three times, it is ready to connect to the Base Station.
  • If it blinks green once, it is connected and communicating with your Base Station.
  • If it blinks red once, it is unable to communicate with the Base Station.

Still won’t connect? Remove then re-add your Panic Button

You might have to remove your Panic Button and then re-add it to your Ring Alarm.

1. In the Ring app, tap the main menu, then tap

   Devices

   , then tap

   Alarm Base Station.

   Select the Panic Button you wish to remove.
2. From your Panic Button’s dashboard tap

   Device Settings

   (gear icon), then tap the

   Remove

   button.
3. Holding your Panic Button in one hand, use your other hand to carefully twist and remove the back cover.
4. Press and hold the pinhole reset button using the end of a paperclip or similar tool.
5. The Ring app will confirm that your Panic Button has been successfully removed.
6. Now, re-add your Panic Button to your alarm system by tapping on

   Set Up a Device

   from the main menu and following the onscreen instructions.

Note: While repeating the setup process, when you’re prompted to pull the battery tab use a small tool, such as a micro screwdriver, to carefully remove the coin cell batteries from the casing of your Panic Button, then reinsert them

If you’re still having trouble connecting your Panic Button, perform a factory reset

1. In the Ring app, tap the main menu, then tap

   Devices

   , then tap

   Alarm Base Station

   . Select the Panic Button you wish to remove.
2. From your Panic Button’s dashboard tap

   Device Settings

   (gear icon), then tap

   Advanced Options

   .
3. Tap

   Remove Failed Device.
4. The app will confirm when your Panic Button has been successfully removed.
5. Factory reset your Panic button by following the instructions below.

How to factory reset your Panic Button

Note: This will remove the device from your Alarm Base Station and reset the device to the original default settings.

1. Remove the cover from the device.
2. Press and hold the pinhole reset button using the end of a paperclip or similar tool until the LED light flashes green (hold for at least 10 seconds).
3. Continue holding down the pinhole reset button until the LED light turns red.
4. Place the back cover back on the device.
5. Now re-add your Panic Button to your Ring Alarm by tapping on

   Set Up a Device

   from the main menu and following the on-screen instructions.

Note: While repeating the setup process, when you’re prompted to pull the battery tab use a small tool, such as a micro screwdriver, to carefully remove the coin cell batteries from the casing of your Panic Button, then reinsert them.

If you have tried all of these steps and your Panic Button still doesn’t work, we recommend reaching out to Customer Support for assistance.