Search Results
Showing results for removed
Installing Outdoor Cam Pro PoE
...Slide the mounting plate in the direction opposite to the UP arrow to remove. Unscrew to detach the camera mount. Remove the middle rubber cap on the back of your camera. Tighten the included hex joint onto the back of your camera, ensuring the...
Installing Stake Mount for Solar Panels and Cameras
...Remove the wired mount arm plate adapter. 4. Using the bottom oval slot, secure your camera with the included hand screw. 5. NOTE: For best results...
Using the adapter plate included with your Ring Video Doorbell 2
...1. Remove your original Ring Video Doorbell Once you have removed the original Ring doorbell and mounting plate, place the adapter plate with it's smaller side (or the beveled edge...
How to install your Ring Video Doorbell Pro with a hardwired transformer
...Mark the holes Using your Ring Doorbell as a template, mark the location of the two mounting holes on your wall. 3.3 Removing the faceplate To access the mounting holes, first remove the faceplate, like this. 3.4 Install anchors (optional) If you’re installing on a hard surface such as concrete...
Installing your Hardwired Kit for Spotlight Cam
...installation and wiring. 2. Remove your existing light or camera (if applicable) With power off at the consumer unit, remove your existing Spotlight Cam Wired from the electrical box and disconnect the wires. If there is a bracket attached to your electrical box, remove that as well...
The difference between the Pro Power Cable and Pro Power Kit v2 (for Ring Video Doorbell Pro)
...Remove the cover from your internal doorbell chime. Loosen the screws holding the doorbell wires. Detach the doorbell wires from the internal doorbell...
Installing No-Drill Mount for Ring battery doorbells
...Remove your doorbell’s faceplate. 5. Attach your doorbell using the four included mounting screws. 6. Refer to your doorbell setup guide to secure your...
Installing Floodlight Cam Wired Pro (2nd Gen)
...10. Slide the camera fixture onto the mounting plate and attach using the included hex nuts. 12. Remove the shank from the included screwdriver and use the handle to tighten the hex nuts. Then, cover with the included hex nut caps. Floodlight Cam Pro...
Installing Floodlight Cam Wired Plus and Pro
...off at the fuse box, remove the existing floodlight from the wall and disconnect the wires. If there is a bracket attached to the wall, remove that as well. Remove the plastic mounting plate from the light fixture. Push gently on the threaded posts visible on the front of the fixture and pull the...
Hardwired Kit for Cameras Installation Guide
...with a minimum torque of 0.4N/m. Connect the brown (L) and blue (N) wires. Note: If you ever need to remove the wires: Remove the brown (L) and blue (N) wires. Then, remove the yellow wired mount bonding conductor wire and the home protective earthing conductor wire...