Search Results for Ring Help
Showing results for attach
Installing lens cover for Outdoor Cam Pro
...Attach the screw cap to the bottom of your camera. 7. Attach the camera mount to the back of your camera with its screw. 8. Reattach the mounting plate by sliding until you hear a click to secure. 9. Refer to your camera setup guide to attach your camera to the wall. Using the lens cover 1. To...
Installing Doorbell Retrofit Kit
...If the retrofit kit starts to flex, the screws are too tight. 6. Clip on the retrofit cover to attach. 7. (Optional) If using a wedge or corner mount, install the mount over the retrofit kit. 8. Attach the doorbell bracket over the mount or retrofit kit...
Installing Stick Up Cam Elite
...bottom cover, slide the cover into place on your Stick Up Cam. Then, tighten the screw with the star-shaped end of the screwdriver bit. Step 7: Attaching the cover to the base Snap the cover onto the base. Secure it with the included short security screw...
Wiring diagrams for wired doorbells
...Attach the bypass harness (D) to the bypass terminal on your Pro Power Kit (C). Connect one wire from the bypass harness (D), now attached to the Pro Power Kit (C), to the Ring doorbell (A). Connect the second wire from the bypass harness (D), now attached to the Pro Power Kit...
Installing Spotlight Cam Pro (2nd Gen) Plug-In
...5. Attach the camera mount to the back of your camera with its screw. 6. Secure your camera to the mounting plate by sliding until you feel a click. NOTE...
Installing No-Drill Mount for Ring battery doorbells
...protective strips from the adhesive tape. 3. Hold the mount against the mounting surface for five minutes and allow an hour for it to adhere. 4. Attach the Wedge or Corner Kit using the two included bracket screws. If installing on a Wedge Kit, insert a screw into a threaded hole on either side of...
Installing Outdoor Cam Plus Plug-In
...on the back of your camera and use it to plug the bottom. 7. Attach the camera mount to the back of your camera with its screw. 8. Plug in the power cable. Be sure the power cable is fully inserted 9. Clasp the camera mount and attach your camera to the mounting plate by sliding until you feel a...
Installing Wired Doorbell Plus
...in the Corner or Wedge Mount. Using the short bracket screws, secure the Corner or Wedge Mount to the wall. You’ll use the 1" mounting screws to attach your Doorbell to the bracket later...
Physically Setting Up Your Ring Jobsite Security Case
...Attach the two hook brackets to the back side of the case using 2 screws per bracket included in Bag B. Similar to how you might mount a TV, slide the...
Outdoor Siren Power Sources
...you begin, make sure the battery cover is off. When you finish connecting your power sources, replace the back cover and tighten the screws. Then attach the Outdoor Siren to the mounting bracket. Tighten the security screw on the bottom of the bracket. Use these directions for each power source...