Search Results for Ring Help
Showing results for step-first
Placing Your Solar Smart Lights for Optimum Performance
...charge, you can always use the micro-USB cable to give your lights a quick charge. Always install your lights with access to direct sunlight The first step in maintaining a good solar charge throughout the year is ensuring your Smart Solar Light is properly installed in a well-lit area that receives...
Installing your Solar Panel (USB-C) (2nd Gen)
...This article outlines the step-by-step process to install the Solar Panel (USB-C) (2nd Gen) . Choose an install location with the most direct sunlight. If you are in the Northern...
Installing Ring Peephole Cam (Door View Cam)
...P1-67 P1-68 P1-77 P1-101 Set up your Ring Peephole Cam (Door View Cam) with this step-by-step guide. If you have an unusual door view, it might interfere with the installation. Learn more about installing Peephole Cam on unusual peepholes...
Setting up Ring Smoke and CO Listener in the Ring app
...Get step-by-step instructions on how to setup your Ring Smoke & CO Listener,¹ where best to place it, and how to test it to make sure it’s working properly. Before...
Troubleshooting your Ring Intercom devices
...first check your wiring. You can find the steps in the wiring issue section above. If you're still experiencing video quality issues, here's what you can do: To adjust your video settings, you can locate Video Tuning in the last step during setup or you can find it in the app using the below steps...
Upgrading from Video Doorbell Elite to Wired Doorbell Elite (2nd Gen)
...from the Ethernet port on the back of the doorbell. Step 4: Disconnecting the doorbell from an in-home doorbell chime (optional) If you did not have your Video Doorbell Elite connected to the in-home doorbell chime, you can skip this step. Electrical hazard. Disconnect power to installation...
How to Factory Reset Your Ring Alarm Devices
...Button (located on the side of the device) for 10 seconds until the LED Ring blinks once, then release the button. Factory Reset your First Alert First Alert Smoke & Carbon Monoxide Alarm 1 (Model SMCO410) With the batteries inserted, press and hold the test button for 30 seconds, releasing after...
Setting up Ring Smart Lighting Bridge
...Set up your Ring Smart Lighting Bridge in the Ring app with this step-by-step guide. Bridge Smart Lighting Set up your Ring Bridge Download the Ring app. The app walks you through setting up and managing your Bridge. Search...
Installing Intercom Kit for Video Doorbells
...Use for Step 3 ONLY. Not for use on wall. Hardware included 1. Warning: Professional installation recommended. Turn off the power to your existing intercom first. 2. Remove your existing intercom. Refer to your existing intercom’s...
Getting started with your Ring Alarm system
...at the bottom of the screen. Tap Set up a Ring Alarm Base Station or Z-wave Sensor . The Ring app will walk you through the setup process, step by step. Once your Base Station is set up and your devices are connected to the Base Station, you can start placing your Contact Sensors and Motion...