Search Results for Ring Help
Showing results for attach
Installing Outdoor Cam
...inferior. 7. Attach the camera mount to the back of your camera with its screw. / Attacher le support à caméra l’arrière de celle-ci avec la vis intégrée au support. / Conecta el montaje de la cámara a la parte trasera de la cámara con su tornillo. 8. Clasp the camera mount and attach your camera...
Installing Ring Sump Pump Monitor
...screws or adhesive backing. On drywall, stucco, brick, or concrete, use a 3/16 (5 mm) masonry bit to drill holes for the included wall anchors. 3. Attach your monitor to the mounting bracket by sliding until you hear a click to secure. NOTE: Ensure the monitor is pointing up. Sump Pump Monitor | 4EN...
Installing Solar Charger for battery-powered doorbells
...Tighten the terminal screws. Fit your doorbell into the Solar Charger and secure with screws. Tuck the retractable wire into the Solar Charger. Attach the faceplate. For doorbells with a built-in battery: Secure the mounting bracket to the Solar Charger with screws. Connect the micro USB cable to...
Installing Ring Candy Cam
...base on a sturdy, level surface. 4. Route the power cable through the hole at the bottom of the base. 5. Route the cable through the mount arm. 6. Attach the mount arm onto the base. Candy Cam | 3 7. Tighten the tapping screws included with your camera to secure. 8. Slide the mounting plate at the...
Installing Window & Door Sensor
...more than 1 in (25.4 mm) between sensor and magnet when closed. Leave at least 1/2 in (12.7 mm) of space to open the battery compartment. 4. Attach the sensor and magnet to the door or window and frame. Amazon Sidewalk-enabled device; requires Amazon Sidewalk coverage for use...
Installing Indoor Cam
...Re-attach the base. Screw it into the back of your Indoor Cam with the “UP” arrow on the bracket pointing upwards. Remove the mounting bracket. Slide it...
Installing Pro Power Kit or Jumper Cable
...and Trans (Transformer). Loosen the terminal screws on both Front and Trans , keeping the original doorbell wiring in place. Step 3: Attach wires Attach Pro Power Kit wires to the Front and Trans terminals next to existing doorbell wires, and tighten terminal screws. Wire orientation between...
Installing Floodlight Cam (1st Gen)
...detailed instructions on wiring your Floodlight Cam bracket, watch the video below. Step Three - Hang your Floodlight Cam Use the included hook to attach Floodlight Cam to your junction box by inserting one end through the mounting hole on your Floodlight Cam and the other end onto the mounting...
Installing Stake Mount for Solar Panels and Cameras
...3. Connect the center pole. 4. Connect the camera mount pole. Solar Panel 1. Attach the solar panel mount. 2. Slide your solar panel into place and wind the cable underneath, leaving enough length to connect to your camera...
Installing Wired Doorbell Elite (2nd Gen)
...properly connected, the front light will begin spinning. 10. Tuck the wires into the wall, then hook your doorbell over the mounting bracket to attach. Wired Doorbell Elite (2nd Gen) | 6EN 11. Tighten the security screws. 12...