Ring Video Doorbell on a modern home.

Installing Stake Mount for Solar Panels and Cameras

Learn how to install Stake Mount for Solar Panels and Cameras use by following these steps.

Hardware included

Hardware includedHardware included

Tools needed

Screwdriver required

Installation

Choose a location.

If installing a solar panel, ensure the mount is positioned under direct sunlight.

Ensure mount is under direct sunlight

1. Drive the spike into the ground.

Drive spike in ground

2. Rotate the base pole to lock and tighten with a screw.

Pole installation

3. Connect the center pole.

Connect center pole

4. Connect the camera mount pole.

Solar Panel

1. Attach the solar panel mount.

Solar panel mount

2. Slide your solar panel into place and wind the cable underneath, leaving enough length to connect to your camera.

Solar panel installation

(Optional) If installing without solar panel, cover with a cap.

Pole cover

Outdoor Cam Plus

1. Unclasp the camera mount.

Unclasp mount

2. Unscrew to detach the camera mount from the battery cover.

Camera mount installation

3. Remove the rubber cap on the back of your camera and use it to plug the bottom.

Remove camera cap

4. Remove the wired mount arm plate adapter.

Arm plate removal

5. Plug in the power cable.

Plugging in cable

6. Using the top oval slot, secure your camera with the included hand screw.

Securing camera

NOTE: For best results, align the side edges of the hand screw with the indented tracks on the back of your mount arm plate.

Outdoor Cam (formerly Stick Up Cam (3rd Gen))

1. Unscrew to detach the camera mount from the battery cover.

Detaching camera mount

2. Remove the rubber cap on the back of your camera and use it to plug the bottom.

3. Remove the wired mount arm plate adapter.

4. Using the bottom oval slot, secure your camera with the included hand screw.

5. NOTE: For best results, align the side edges of the hand screw with the indented tracks on the back of your mount arm plate.

6. Plug in the power cable.

Spotlight Cam

1. Remove the camera backplate.

2. Slide onto the camera mount.

3. Plug in the power cable.

Adjusting your mount

Loosen the knob to adjust camera angle, then tighten to secure.

Rotate the camera mount pole 360 degrees.

Loosen ring to tilt or rotate solar panel mount, then tighten to secure.

Last updated 1 week ago