Search Results
Showing results for strips
Setting up and using your Ring Alarm Motion Detector
...mounting bracket onto the back of the Motion Detector. Ensure the mounting surface is clean and dry before peeling the backing off of the adhesive strip...
Install No-Drill Mount for battery doorbells
...a doorbell with a mounting bracket 1. Choose a smooth, even mounting surface, and wipe it clean. Do not install on glass. 2. Remove the protective strips from the adhesive tape. 3. Hold the mount against the mounting surface for five minutes and allow an hour for it to adhere. 4...
Replacing the cable on your Door View Cam
...Remove the adhesive The replacement cable will have an adhesive strip that is used to attach it to the tube. Peel the backing off the adhesive strip and attach the cable to the tube in the same location you removed the old cable. Plug in the new cable With the old cable removed, plug the...
Safety and compliance information for No-Drill Mount
...1. Remove the security screws. 2. Flip the pull-tabs up. 3. Remove No-Drill Mount. While firmly holding the mount, gently pull up on the adhesive strips until the mount releases from the wall. 34 32 Retrait 1. Retirer les vis de sécurité. 2. Retourner les languettes vers le haut...
Hardwired Kit for Cameras Installation Guide
...Hardware included: Tools needed: Use PH2 screw driver to prevent stripping screw. Junction box Before you begin installing your Hardwired Kit, make sure that you’re following safety code standards. WARNING: Risk of...
Installing and using Ring Alarm Contact Sensor
...the backplate is connected to the Sensor. Make sure that the mounting surface is clean and dry before peeling the backing off of the adhesive strip. Install the sensor and magnet on a door or window and frame by pressing it into place for 20 seconds. Make sure there is no more than 1.25 cm...
Installing and using Ring Alarm Glass Break Sensor
...your Glass Break Sensor: Mounting with double-sided tape Ensure the mounting surface is clean and dry. Peel the backing off of the adhesive strip. Firmly press and hold the sensor in place for 20 seconds to ensure it is securely attached...
Troubleshooting your Ring Intercom devices
...your existing intercom is compatible with Ring Intercom using our compatibility checker ring.com/intercom-compatibility-checker Ensure the pre-stripped ends of the included Ring Intercom cable have been removed before you begin installing your Ring Intercom device. Ensure the original building...