Search Results
Showing results for adhesive
Install No-Drill Mount for battery doorbells
...mounting bracket 1. Choose a smooth, even mounting surface, and wipe it clean. Do not install on glass. 2. Remove the protective strips from the adhesive tape. 3. Hold the mount against the mounting surface for five minutes and allow an hour for it to adhere. 4...
Install and use your Ring Alarm Panic Button
...Keep the Panic Button out of the reach of small children and pets. Follow these steps to physically install your Panic Button: Pre-attached adhesive Clean the mounting location. Peel the rubber pads off of the bottom cover to expose the adhesive tape. Press the Panic Button firmly to the...
Replacing the cable on your Door View Cam
...or tube). Remove the adhesive The replacement cable will have an adhesive strip that is used to attach it to the tube. Peel the backing off the adhesive strip and attach the cable to the tube in the same location you removed the old cable. Plug in the new cable With the old cable removed, plug the...
Safety and compliance information for No-Drill Mount
...3. Remove No-Drill Mount. While firmly holding the mount, gently pull up on the adhesive strips until the mount releases from the wall. 34 32 Retrait 1. Retirer les vis de sécurité. 2. Retourner les languettes vers le haut. 3. Retirer...
Positioning Alarm Contact Sensors on different types of doors, windows and trim
...to lever the back of the magnet component of the Contact Sensor. Remove the slim magnet. Install the slim magnet next to the sensor, using the adhesive pad. Window or door that is not flush with the frame or moulding Make sure that the Contact Sensor and magnet are less than 2.5 cm apart...
Installing your Contact Sensor (2nd Generation)
...Remove the slim magnet. Install the slim magnet next to the sensor, using the adhesive pad. Using a Ring Alarm Contact Sensor Riser If you are still having a problem getting your Contact Sensor positioned correctly, a Ring Alarm...
Installing and using Ring Alarm Contact Sensor
...Gen) Confirm the backplate is connected to the Sensor. Make sure that the mounting surface is clean and dry before peeling the backing off of the adhesive strip. Install the sensor and magnet on a door or window and frame by pressing it into place for 20 seconds. Make sure there is no more than 1.25...
Setting up and using your Ring Alarm Motion Detector
...mounting bracket onto the back of the Motion Detector. Ensure the mounting surface is clean and dry before peeling the backing off of the adhesive strip...
Installing and using Ring Alarm Glass Break Sensor
...install your Glass Break Sensor: Mounting with double-sided tape Ensure the mounting surface is clean and dry. Peel the backing off of the adhesive strip. Firmly press and hold the sensor in place for 20 seconds to ensure it is securely attached...