Search Results
Showing results for holes-from'
Installing Spotlight Cam (2nd Generation)
...or concrete, use a 1/4 in (6 mm) masonry bit to drill holes for the included wall anchors. 2. Use the mounting plate as a guide to mark screw holes on the wall with 5.5 in (14 cm) of space in every direction. 5.5 in (14 cm) 5.5 in (14 cm) 5.5 in (14 cm) 5...
Installing Wired Doorbell Pro (3rd Gen) Hardwired
...bottom sections, ensuring it is facing in your desired viewing direction. On stucco, brick, or concrete, use a 6 mm (1/4 in) masonry bit to drill holes for the included wall anchors. (Optional) If using a wedge mount, install the mount over your doorbell wires using the screws included with your...
Installing Spotlight Cam Pro (2nd Gen) PoE
...into the centre of the junction box. 10. Attach the metal crossbar with the screws included with your adapter, starting with the closed screw hole. 11. Close the junction box with the cover mount. 12. Tighten the centre screw to secure the junction box cover mount in place. 13. Cover the...
Solar Panel (Barrel Connector) for Spotlight Cam and Outdoor Cam (formerly Stick Up Cam, 3rd Gen) Battery
...the provided screws and screwdriver. If you are mounting to brick, concrete, or stucco, do the following: Mark the holes where you wish to mount your the Solar Panel. Drill a hole for the anchors using the provided drill bit. Insert the anchors. Use the screws to secure the mount. How do I aim...
Troubleshooting Ring Alarm Motion Detectors
...red, then release. To reset a Motion Detector (1st Gen): Make sure the battery is inserted, and the cover is completely closed. Look for a small hole on the back of your device. Use a paperclip to press and hold the reset button inside this hole. When you press the button, the light on the front...
Installing Wired Video Doorbell Pro (3rd Gen) Plug-In
...for electrical wiring and pipes when drilling. 3. (Optional) If using a corner mount, install the mount over your doorbell wires using the bottom holes in the top and bottom sections, ensuring it is facing in your desired viewing direction. NOTE: Multiple corner mounts can be stacked together. We...
How to completely reset your Alarm devices
...If not already done, remove the device from its mounting bracket. On the back of the device, using a paperclip (or similar) press and hold the pin hole button. Continue holding the button for ~10s watching the LED blink rapidly blue...
Installing Outdoor Cam Plus Plug-In
...installation 1. Slide the mounting plate in the direction opposite to the UP arrow to remove. 2. Use the mounting plate as a guide to mark screw holes on the wall. 3. Install the mounting plate with the UP arrow pointing up. On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to drill...
Installing Wired Video Doorbell Elite (2nd Gen)
...can be installed on a flat surface or directly over existing wiring. 2. Use the surface mount as a guide to mark screw holes on the wall. 3. Route the wiring through the center hole, ensuring cables are not pinched or kinked. 4. Install the surface mount with the included screws. On stucco, brick...
Installing Outdoor Cam Plus Battery
...on the wall. 3. Install the mounting plate with the UP arrow pointing up. On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to drill holes for the included wall anchors. 4. Unclasp the camera mount. 5. Unscrew to detach the camera mount from the battery cover. 6. Remove the rubber cap...