Search Results
Showing results for installable
Positioning Alarm Contact Sensors on different types of doors, windows and trim
...the casing so that it fits into the available space. To remove and install the slim magnet: Use a small flathead screwdriver to lever the back of the magnet component of the Contact Sensor. Remove the slim magnet. Install the slim magnet next to the sensor, using the adhesive pad. Window or...
Safety and compliance information for Ring Wired Video Doorbell Pro (3rd Gen)
...with connected devices. DIN Rail Transformer must be installed in a suitable enclosure and in a controlled indoor environment. The disconnect device for this equipment shall be provided as part of the building installation and in a readily accessible location. Ensure that there is at...
Spotlight Cam Mount Installation
...Learn how to install your Hardwired Kit for Spotlight Cam Wired/Mount...
Safety and compliance information for Ring Floodlight Cam Wired Pro
...if the wires or housing are defective, there is a risk of electric shock. Do not cut any wires with factory installed wire connectors or remove the wire connectors. Do not install on circuits feeding motor loads such as kitchen appliances, HVAC equipment, washer / dryer or garage door openers...
Hardwired Kit for Spotlight Cam Information
...wiring. Security Screw: Used to secure your Spotlight Cam to the box cover. How do I install the Hardwired Kit for Spotlight Cam? Learn how to install the Hardwired Kit for Spotlight Cam. How high should my Spotlight Cam be mounted off the ground...
Replacing the cable on your Door View Cam
...inserting your Door View Cam through the door easier. Reinstall your Door View Cam Once the cable is installed, simply reinstall the Door View Cam in your door. Get instructions on installing your Door View Cam...
Control pan-tilt cameras in the Ring app
...off, the device will calibrate by panning and tilting in each direction. Make sure there is 16.5 cm (6.5 inches) of clearance on all sides when installing your camera to allow this movement. Note: If you’re installing Pan-Tilt Indoor Cam on a shelf or tabletop, place the camera away from the edge...
Bypass a Contact Sensor with Ring Alarm Quick Exit
...must disarm your Ring Alarm using the app 1 or Keypad. Additional details about Quick Exit Quick Exit can only be used on doors that have been installed with a Contact Sensor (2nd Generation) . Quick Exit is not available for Outdoor Contact Sensor or Contact Sensor (1st Generation). Quick Exit...
Troubleshooting tampered Contact Sensors
...make sure that the device is properly positioned at your window or door. Disarm your Ring Alarm system. Check that the batteries are properly installed and the cover is securely in place. To retry connection: Open the Ring app to the main dashboard. Tap the Alarm tile under Devices. Tap...
Ring devices and extreme temperatures
...the overall lifetime of your battery. Install your device in a shaded area if possible. Charging in hot weather If your device gets too hot, it will not charge and can completely shut down. You might need to take it inside to cool down and then install it in a shaded area, if possible...