Search Results
Showing results for walls
Installing your Stick Up Cam Battery (2nd Gen)
...Installing Stick Up Cam on a wall or ceiling If you're mounting Stick Up Cam on a wall: Push the rubber pad into the top of the base. Flip the base toward the rear. If you're mounting Stick Up Cam on a ceiling: Swivel the base above...
Installing Outdoor Cam Plus Battery
...accordingly. 2. Tighten the security screw on the battery cover. Wall installation 1. Slide the mounting plate in the direction opposite to the UP arrow to remove. 2. Use the mounting plate as a guide to mark screw holes on the wall. 3. Install the mounting plate with the UP arrow pointing up. On...
Installing Spotlight Cam Plus or Pro
...brick, or stucco) surface: Mark four screw holes using the plate as a guide. Drill pilot holes using a 6 mm drill bit. Insert the included wall anchors, then drive the four mounting screws through the mounting plate into the wall anchors. Step 7: Attach the camera mount to the mounting...
Installing Intercom Kit for Video Doorbells
...Use for Step 3 ONLY. Not for use on wall. Hardware included 1. Warning: Professional installation recommended. Turn off the power to your existing intercom first. 2. Remove your existing...
Installing lens cover for Outdoor Cam Pro
...6. Attach the mount to the bottom of your camera with its screw. 7. Reattach the mounting plate by sliding until you hear a click to secure. Wall Installation FOR INDOOR USE ONLY 1. Slide the mounting plate in the direction opposite to the UP arrow to remove. 2. Unscrew to detach the camera...
No-Drill Mount for Ring Video Doorbell (2nd Generation)
...2nd Generation) if you can't drill holes into your outside wall. The No-Drill Mount uses double-sided adhesive to attach the plate to your wall so you can securely screw your Ring Video Doorbell directly onto the mounting plate — no power tools required. Installing the Ring No-Drill Mount...
Installing Spotlight Cam Pro (2nd Gen) PoE
...on the wall or ceiling with the included screws. On stucco, brick, or concrete, use a 6mm (1/4 inch) masonry bit to drill holes for the included wall anchors. 3. Cover the screw holes with the included rubber caps. Spotlight Cam Pro (2nd Gen) | 4EN 4. Disassemble the cable gland by unscrewing the...
Installing Floodlight Cam Wired Plus and Pro
...With power off at the fuse box, remove the existing floodlight from the wall and disconnect the wires. If there is a bracket attached to the wall, remove that as well. Remove the plastic mounting plate from the light fixture. Push gently on the threaded posts visible on the front of the...
Installing Video Doorbell Elite
...the hole in the mount. 3. Use a screwdriver to tighten the screws. The wing clamps will rotate as the screws turn, locking the bracket to the wall. Step 3: Plugging in the Ethernet cable The Video Doorbell Elite must be connected to power using Power over Ethernet. Plug the Ethernet cable into...
Using a Wedge Kit or Corner Kit with your doorbell
...on the Wedge or Corner kit to align with the existing screw holes. Step 4: Preparing the mounting surface Installing on a wood surface Drills and wall anchors are not needed. Installing on a masonry surface Using the marked screw hole locations, drill pilot holes using a 1/4” or 6mm drill bit...