Install Ring Video Doorbell 2 Without an Existing Doorbell
Before you get started, be sure to begin setting up your Video Doorbell 2 in the Ring app.
Charge the battery
- Fully charge the battery by plugging it into a power source using the provided orange cable.
- The light will be green when fully charged.
- Insert the battery into the bottom of your Ring Video Doorbell 2 until it clicks into place.
Line up your Ring Video Doorbell 2
To properly line up your Ring Video Doorbell 2:
- Click the level tool (included in the box) into the small hole on the front of the Ring Video Doorbell 2 below the camera.
- Place the Ring Doorbell 2 next to your door at about chest height (4 feet).
- Level the device using the level tool.
- Mark the positions for mounting holes with a pencil.
Drill holes
Optional: Use a drill to drill holes where you marked the position of the mounting holes.
- If you are mounting the Ring Doorbell 2 on brick, concrete, or stucco, use the plastic anchors included in the box. You may need to use a hammer to get the anchors in.
- If you are mounting the bracket on wood or vinyl, use the screws included.
Place your Ring Video Doorbell over the holes
- Don't forget to remove the level tool from the front of the device.
Screw in the Ring Video Doorbell 2
- Be sure you use all four screws that are included.
Install the faceplate
- Place one of the provided faceplates on your Ring Video Doorbell 2 by slotting it in at the top and clicking it into place.
Tighten the security screw
Use one of the provided security screws and the star-shaped end of the screwdriver part to secure the faceplate.
Last updated 9 months ago