Search Results for Ring Help
Showing results for tool
Replacing your Ring Alarm Base Station
...Contact Sensor (2nd gen) Remove the cover from the device. Press and hold the pinhole reset button using a paperclip or the included pinhole tool. The LED light will flash green. 3. Continue holding down the pinhole reset button until the LED light turns solid red, then put the back cover...
Installing Ring Peephole Cam (Door View Cam)
...peephole (door view) from both sides of door. This will allow for easy removal of the original peephole (door view). Inside Outside 2. Put the tool’s flat edge in the slots to unscrew. 3. Remove peep lens. 4. Smooth out the hole’s edges with the tool. 5. From the outside, insert your Peephole...
Checking Device Health in the Ring App
...Status : This will show if the device is online or offline. Change network: This tool allows you to change your wifi network. You must be near your device and have your wifi password handy. Wifi passwords are case sensitive. Device...
Installing Wired Doorbell Elite (2nd Gen)
...marks are trademarks of Ring LLC or its affiliates. Hardware included Tools needed Flathead screwdriver Phillips-head screwdriver Tools included Removal tool 1. Remove the protective wrap. 2. Download the Ring app. 3. Scan the QR code on your device...
Setup and Install your Ring Beacon
...Ring and all related marks are trademarks of Ring LLC or its affiliates. Install your Ring Beacon with these step-by-step instructions. Tools Needed: 1. Unscrew to remove the back cover. 2. Remove the battery pull-tab. 3. Fully charge your sign with a USB-C Cable (not included) NOTE...
Installing Wired Doorbell Pro (3rd Gen) PoE
...Hardware included Tools included Removal tool Tools needed Phillips-head screwdriver Drill with a 1/4 in (6 mm) masonry bit (optional) Remove the protective wrap. 2. Download the Ring app. 3. Scan...
Installing No-Drill Mount (2nd Gen) for Battery Doorbell (2nd Gen) devices
...sided adhesive to attach the plate to your wall so you can securely screw your Ring Battery Doorbell directly onto the mounting plate, no power tools required. Important note : Make sure you have the correct No-Drill Mount (2nd Gen) for Battery Doorbell (2nd Gen) for your Ring Battery Doorbell...
Installing Ring Candy Cam
...Get step-by-step instructions for your Ring Candy Cam installation. Candy Cam | 1 Hardware Needed From Outdoor Cam Pro Tools Needed Phillips-head screwdriver 2. Choose a location near an outlet. Mount installation 1. Refer to your camera setup guide to set up your camera...
Installing Ring Retrofit Alarm Kit
...Tools and supplies you may need for installation Required supplies: Ring Retrofit Alarm Kit, with the included #1 Phillips head screwdriver A screwdriver that fits your existing wired alarm panel terminals A continuity tester or multimeter Additional supplies you may need: A wire stripping tool...
Installing Wedge Kit for Wired Doorbell Pro (3rd Gen)
...these step-by-step installation instructions for your Wedge Kit for Wired Doorbell Pro (3rd Gen). Hardware Included Tools Included Removal tool Tools Needed Phillips-head screwdriver Drill with a 1/4 in (6 mm) masonry bit (optional) 1. Refer to your doorbell setup guide to prepare your install...