Search Results for Ring Help
Showing results for tape
Set up and install Ring Intercom Audio or Ring Intercom Video
...Ring app to test that everything works okay. Removing Ring Intercom device and double-sided tape To remove your Ring Intercom device's double-sided tape from the wall: Grip the device with one hand while using your other hand to pull the transparent tabs slowly, following the tape's direction. Pull...
Installing and using Panic Button (1st Gen)
...the sensor closer to the Base Station, or use a Range Extender to strengthen communication. How to mount your Panic Button Using the double-sided tape: Clean the mounting location. Peel the liners on both sides to expose the adhesive tape. Press the Panic Button firmly to the mounting location and...
Installing and using Ring Alarm Panic Button (2nd Gen)
...or discreetly under a desk or table. Tape Mounting Clean the mounting location, then peel the rubber pads off of the bottom cover to expose the adhesive tape. Press the Panic Button firmly to the mounting location and hold for 20 seconds to make sure the tape is securely attached. Screw Mounting...
Where to Download a Ring Sticker
...You can also purchase a Solar Security Sign , which charges during the day and lights up at night, or a Doorplate Sign which can be drilled or taped to doors or fences. Audio/Video Recording Enregistrement audio/vidéo Grabación de audio/video...
Installing Ring Retrofit Alarm Kit
...tool Extra 20 or 22 gauge wire Twist on wire nuts or wire connectors Cleaning cloth or alcohol to clean the wall before using the included mounting tape If you prefer to mount this device using screws, two screws and anchors to mount the Retrofit Alarm Kit on the wall near your wired alarm panel...
Installing Your Ring Car Cam Holder
...Let dry a few minutes. 3. Remove the tape and gently place. Without the Car Cam device inserted, peel back the adhesive tape on the holder and place it on the chosen lower portion of the windshield – ensuring you stay clear of any of your vehicle's sensors. It should sit...
Ring Alarm (2nd Gen) Installation Guide
...give it a unique name and assign it to a room. . Install If you’re mounting the Motion Detector on a wall, peel the backing o the pieces of tape located on the back. If mounting it in a corner, peel the backing o the tape on each of the corners. Motion Detector in a corner Motion Detector...
Installing and using Ring Alarm Outdoor Contact Sensor
...the magnet are lined up, and 2.5cm apart or less. • Mounting Tape (included) Use the included mounting tape, clean the area, then peel the backing and stick the sensor. Press it to the surface and hold for 20 seconds to make sure the tape is securely attached...
Setting up and using Ring Alarm Motion Detector (all generations)
...the included mounting bracket onto the back of the Motion Detector. (2nd Generation) Motion Detector does not have a mounting bracket. Mounting tape can be found on the back of Detector. Ensure the mounting surface is clean and dry before peeling the backing off of the adhesive strip...
Download the manual for Ring devices
...than one mounting method, if needed. Make sure the sensor and the magnet are lined up, and 2.5cm apart or less. • Mounting Tape (included) Use the included mounting tape, clean the area, then peel the backing and stick the sensor. Press it to the surface and hold for 20 seconds to make sure the...