Search Results for Ring Help
Showing results for installable
Installing No-Drill Mount for Ring battery doorbells
...7. Refer to your doorbell setup guide to secure your doorbell. Installing a doorbell with a mounting bracket on a Wedge or Corner Kit 1. Choose a smooth, even mounting surface, and wipe it clean. Do not install on glass. 2. Remove the protective strips from the adhesive tape. 3. Hold...
Installing the Pan-Tilt Mount for Outdoor Cam
...power adapter directly into the Pan-Tilt Mount, not the . Step 5: Mount on a wall 1. Install the mounting plate. If installing on a wood surface: Screw the mounting plate directly into the wall. If installing on a masonry (concrete, brick, or stucco) surface: Mark four screw holes using the...
Installing Wired Doorbell Pro (3rd Gen) Hardwired
...bit to drill holes for the included wall anchors. 9. (Optional) If installing multiple wedge or corner mounts, insert screws through both mounts to hold them together. NOTE: We do not recommend more than two. 10. Install the mounting bracket on your mount or directly over your doorbell wiring...
Setting up and installing your Ring Alarm Base Station
...Installing your Base Station You can install your Base Station almost anywhere. Place it on a flat surface or mount it on a wall. Screws and anchors are not included...
Installing Floodlight Cam Wired Plus and Pro
...outwards. Step 5: Install the plastic mounting plate Align the plastic mounting plate with the junction box, and feed the power wires through the opening. Note: If attached to the camera, pull gently to release the plastic mounting plate from the device. If you are installing the camera on a wall...
Installing Stick Up Cam (2nd Gen) for Battery Use
...anywhere, indoors or out. It can sit on its own stand, or mount to a wall or ceiling. Choose a spot where it can provide the view that you want. Installing Stick Up Cam on a shelf or table: Place the rubber pad on the bottom of the base. Snap the cover onto the base. Place your Stick Up Cam on...
Installing Spotlight Cam (1st Gen), Mount
...Cam is installed, it's time to turn the power back on at the breaker. If the lights on your Spotlight Cam turn on, you're ready to go! If not, turn off power at the breaker and check your connections. 11. Set up your Spotlight Cam in the Ring app. After physically installing your Spotlight...
Installing Spotlight Cam Pro (2nd Gen) Plug-In
...3. Install the mounting plate with the UP arrow pointing up. On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to drill holes for the included...
Installing Wired Doorbell Pro (3rd Gen) PoE
...a 6 mm (1/4 in) masonry bit to drill holes for the included wall anchors. 7. (Optional) If installing multiple wedge or corner mounts, insert screws through both mounts to hold them together. 8. Install the mounting bracket on your mount or directly over the spacer with the included screws. 9...
Installing and using Panic Button (1st Gen)
...and screws 3V lithium CR2032 battery comes pre-installed Setting up your Ring Alarm Panic Button (1st Gen) Before installing your Panic Button, set it up in the Ring app. Learn more about setting up and managing Alarm devices in the Ring app. Installing the Panic Button (1st Gen) Choosing a...