Search Results for Ring Help
Showing results for anchor
Installing Outdoor Cam
...using a 0.24 in (6 mm) drill bit. Insert the included wall anchors, then drive the four mounting screws through the mounting plate into the wall anchors. Connect camera to the mounting plate 1. Unscrew the base using a Phillips head screwdriver. 2. Secure the base to the camera's back, with the UP...
Installing Wired Doorbell (2nd Gen)
...wiring with the included screws. Note: On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to drill holes for the included wall anchors. Wired Doorbell (2nd Gen) | 5EN 10. Mount your doorbell by hooking it over the bracket. 12. Restore power at the breaker. 11...
Installing Wedge Kit for Wired Doorbell Pro (3rd Gen)
...included screws, ensuring it is facing down. On stucco, brick, or concrete, use a 6 mm (1/4 in) masonry bit to drill holes for the included wall anchors. 4. If installing multiple wedge or corner mounts, insert the included screws through both mounts to hold them together. NOTE: We do not...
Installing and using Ring Alarm Outdoor Contact Sensor
...into place and screw in the brackets. If mounting on a softer surface like wood, simply screw in the brackets. • 4 screws included: 3x21mm • 4 anchors included: 5x25mm • Metal cable ties (not included) Feed the metal cable ties through the back of the sensor and magnet brackets. Make sure that...
Ring Alarm (2nd Gen) Installation Guide
...Keypad. • Place the mounting bracket on the wall, then use the wall anchors and screws from your kit to fasten the bracket to the wall. (If using anchors, you should pre-drill holes.) • Slide the Keypad onto the bracket. Install steps: . Connect When prompted by the app, plug the Keypad into an...
Installing the Pan-Tilt Mount for Outdoor Cam
...using a 0.24 in (6 mm) drill bit. Insert the included wall anchors, then drive the four mounting screws through the mounting plate into the wall anchors. 2. Connect the power cable. Feed the power cable through the cut-out in the wall mount. Then, plug it directly into the Pan-Tilt Mount, not the...
Hardwiring your battery-powered Ring doorbell
...a Wedge Kit, Corner Kit , or mounting bracket with your device, install before mounting the doorbell. Installing on a wood surface Drill and wall anchors are not needed. Installing on a masonry surface Using the marked screw hole locations, drill pilot holes using a 1/4 inch (6 mm) drill bit...
Physically Setting Up Your Ring Jobsite Security Case
...of the case using 2 screws for each plate from Bag B. Secure the floor mounting plates to the floor or a beam using the included screws and anchors...
Installing Wedge Kit for Wired Doorbell Plus (2nd Gen)
...with the included screws, ensuring it is facing down. On stucco, brick, or concrete, use a 6 mm masonry bit to drill holes for the included wall anchors. 4. If installing multiple wedge or corner mounts, insert the included screws through both mounts to hold them together. NOTE: We do not...
Installing Wired Doorbell Plus (2nd Gen)
...your wedge kit, ensuring it is facing down. On stucco, brick, or concrete, use a 6 mm (1/4 in) masonry bit to drill holes for the included wall anchors. 9...