Search Results for Ring Help
Showing results for mount
Installing Wired Doorbell Pro (3rd Gen) PoE
...included wall anchors. 7. (Optional) If installing multiple wedge or corner mounts, insert screws through both mounts to hold them together. 8. Install the mounting bracket on your mount or directly over the spacer with the included screws. 9...
Outdoor Cam Pro
...Pro • Camera mount • PoE+ Adapter and mount • Installation tools and screws • Quick Start Guide • Warranty and safety document • Security sticker Compatible Accessories • 18W Indoor/Outdoor USB-C Power Adapter • PoE+ Converter Mount • PoE+ Adapter with Mount • Hardwired Kit for Outdoor Cam Pro and...
ProductInstalling Stick Up Cam (2nd Gen) for Wired Use
...Step Four: Mounting Stick Up Cam to a wall or ceiling with a rubber pad If you're mounting Stick Up Cam on a wall: Push the rubber pad into the top of the base Flip the base toward the rear. If you're mounting Stick Up Cam on a ceiling: Swivel the base above...
Tips for Installing Contact Sensor (2nd Gen)
...or switch them around. For curved or decorative moulding: Mount the Contact Sensor or magnet at an angle on curved or decorative moulding. For a closed window or door that is not flush with the frame or moulding: Use an offset mount for the Contact Sensor and magnet if the closed window or door...
Installing Indoor Cam Plus
...for the included wall anchors. Indoor Cam Plus | 5EN 4. Plug the power cable into your camera. 5. Swivel your camera’s mount toward the back. 6. Secure your camera to the mounting plate by sliding until you feel a click...
Installing and using Ring Alarm Panic Button (2nd Gen)
...It can also be mounted to a wall, or discreetly under a desk or table. Tape Mounting Clean the mounting location, then peel the rubber pads off of the bottom cover to expose the adhesive tape. Press the Panic Button firmly to the mounting location and hold for 20 seconds to...
Installing Stick Up Cam Elite
...of the base against your ceiling, rubber-side down. Then mount it with the included screws. Then, head to page 14 for the final steps. Rotate the stand above the camera: The whole stand can rotate on its axis. Before ceiling- mounting, rotate the stand 180 degrees so the base is positioned...
Installing Outside Door Sensor
...Attach the mounting brackets to the door or window and frame. NOTE: Ensure no more than 1 in (25.4 mm) between sensor and magnet when closed. Leave at least 1/2 in...
Installing Your Mailbox Sensor
...8. Mount your sensor on the inside of the mailbox lid with an included adhesive. 9. Mount the hexagonal end of the antenna to the outside of your mailbox with an included adhesive. 10. If you drilled a hole, wrap the included grommet...
Installing Pan-Tilt Indoor Cam
...until you feel a click. Secure your camera and bracket to the mounting plate by sliding until you feel a click. Ceiling installation Use the mounting plate as a guide to mark screw holes on the ceiling with 6.5 inches (16.5 cm) of space in every direction. Install the mounting plate with the UP...