Search Results for Ring Help
Showing results for facilities-hole'
Installing Spotlight Cam (2nd Gen)
...or concrete, use a 1/4 in (6 mm) masonry bit to drill holes for the included wall anchors. 2. Use the mounting plate as a guide to mark screw holes on the wall with 5.5 in (14 cm) of space in every direction. 5.5 in (14 cm) 5.5 in (14 cm) 5.5 in (14 cm) 5...
Installing Spotlight Cam Pro (2nd Gen) Plug-In
...installation 1. Slide the mounting plate in the direction opposite to the UP arrow to remove. 2. Use the mounting plate as a guide to mark screw holes on the wall with 5.5 in (14 cm) of space in every direction. 3. Install the mounting plate with the UP arrow pointing up. On stucco, brick, or...
Installing Ring Candy Cam
...Place the base on a sturdy, level surface. 4. Route the power cable through the hole at the bottom of the base. 5. Route the cable through the mount arm. 6. Attach the mount arm onto the base. Candy Cam | 3 7. Tighten the tapping...
Installing Solar Charger for Battery Doorbells (2026)
...facing up and out. NOTE: If installing a corner mount, skip to step 5. On stucco, brick, or concrete, use a ¼ in (6 mm) masonry bit to drill holes for the included wall anchors. 4. (Optional) If installing a wedge mount, mount it directly onto your solar charger with the included screws. 5...
Installing your Video Doorbell Wired
...drill holes in your wall, then insert the included wall anchors. (If you’re installing on wood or siding, you can skip this step.) Mark the screw holes. Using your Ring Doorbell as a template, mark the location of the two mounting holes on your wall. Watch the video guide for installing Video...
Installing Outdoor Cam Plus Plug-In
...on the wall. 3. Install the mounting plate with the UP arrow pointing up. On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to drill holes for the included wall anchors. 4. Unclasp the camera mount. 5. Unscrew to detach the camera mount from the battery cover. 6. Remove the rubber cap...
Installing Video Doorbell Elite
...supplied template. Then, cut a rectangular hole in your wall to make room for the Elite Mounting Bracket. 2. Feed any existing wires through the hole in the mount. 3...
Installing Stick Up Cam Elite
...app. Note: Keep this cover within reach. When you connect your Ethernet cable to the Stick Up Cam, you will need to thread the cable through the hole in the cover. Step 2: Choosing your location Stick Up Cam Elite is designed to be installed just about anywhere, indoors or out. It can sit on its...
Installing Spotlight Cam (1st Gen) for Battery, Solar, and Wired
...Gen) Before installation, mark the mounting hole positions using the mounting bracket. If installing on a wood surface , screw the mounting plate directly into the wall. If installing on a masonry (concrete, brick, or stucco) surface, mark four screw holes using the plate as a guide...
Installing and using Ring Alarm Panic Button (2nd Gen)
...so the unlock symbol is aligned with the indicator. Pull to separate, then set the Panic Button aside. If installing on drywall, drill pilot holes in the mounting surface using a 3/16 in. (5 mm) drill bit. Insert the wall anchors. Position the back cover over the anchors and screw it into...