Search Results for Ring Help
Showing results for anchor
Installing the Surface Mount Box for Wired Doorbell Elite (2nd Gen)
...On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to drill holes for the included wall anchors. 5. Attach your doorbell’s mounting bracket to the surface mount with the included screws. 6. Follow your doorbell’s setup guide to complete...
Installing Spotlight Cam Plus and Pro
...using a 0.25 in (6 mm) drill bit. Insert the included wall anchors, then drive the four mounting screws through the mounting plate into the wall anchors...
Installing and using Ring Alarm Panic Button (2nd Gen)
...Mounting bracket, anchors, and screws Twist the bottom cover counterclockwise, so the unlock symbol is aligned with the indicator. Pull to separate, then set the Panic...
Installing Indoor Cam Plus
...plate with the UP arrow pointing up. On stucco, brick, or concrete, use a 3/16 in (5 mm) masonry bit to drill holes for the included wall anchors. Indoor Cam Plus | 5EN 4. Plug the power cable into your camera. 5. Swivel your camera’s mount toward the back. 6. Secure your camera to the...
Safety and Compliance information for Ring Alarm Pro
...for #8 x 1-inch screws Two #8 x 1-inch pan head screws Installation: Drill two holes with a 3/16“ wood or masonry bit (as needed) for the anchors. These holes should be 58mm apart to fit the slots on the back of the Alarm Pro. Insert the anchors into the wall, then insert the screws. Mount...
Video Doorbell 2
...Pack and Micro USB charging cable Adapter plate Miniature level Screwdriver handle Two-sized screwdriver bit Screws Screw anchors Drill bit for anchors User Manual Installation instruction guide Diode Wire extensions Wire nuts Corner wedge Mount wedge Two interchangeable faceplates Software...
ProductInstalling Outside Door Sensor
...2. Install the mounting brackets. On stucco, brick, or concrete, use a 3/16 in (5 mm) masonry bit to drill holes for the included wall anchors. 3. Slide the sensor and magnet onto the mounting brackets to secure. 4...
Installing Outdoor Cam Plus Battery
...On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to drill holes for the included wall anchors. 4. Unclasp the camera mount. 5. Unscrew to detach the camera mount from the battery cover. 6. Remove the rubber cap on the back of your camera...
Installing Pan-Tilt Indoor Cam
...brick, or concrete, use a 3/16 inch (5 mm) masonry bit to drill holes for the included wall anchors. Secure your camera to the mounting plate by sliding until you feel a click. Plug in the power cable. Anchor the power cable to the wall or ceiling with the included cable clip...
Installing Access Controller Pro
...anchors if needed). Insert mounting screws into device housing. Align device with pilot holes. Secure device with power drill. If you are using anchors, insert them into the wall. Installing with 3M sticky tape or Velcro Step 5: Setting up and activating Ring Access Controller Pro 2 Once your...