Search Results for Ring Help
Showing results for fixture
Updating the Firmware on your Smart Solar Lighting
...If one of these devices is installed on a fixture with a switch and the switch is turned off, the firmware update will fail and the device will appear offline. Firmware updates rely on good...
Connecting external lights to Spotlight Cam Mount (1st Gen)
...you can use the external light toggle in the Ring app to turn external lights on and off. Connecting external lights If you’d like other light fixtures (such as floodlights) to be triggered by the motion detector in your Spotlight Cam Mount or turned on and off with the Ring app, wire them...
Resetting your Ring Smart Lightbulb
...bulb to an outlet on a switch. We do not recommend performing a reset by unplugging and plugging back in a fixture. Instead move the bulb to a fixture with a switch and perform the reset then move bulb back to the original fixture...
Placing Your Solar Smart Lights for Optimum Performance
...Solar Panel Maintenance As outdoor fixtures, it's likely your solar panels will get covered in dirt and debris from time to time. Additionally, if you live in a climate which gets snow or...
Download the manual for Ring devices
...light fixture, leaving about 12” of cable after the last fixture. Connect the light fixtures to the cable. Secure the light fixtures to the cable according to the fixture manufacturer’s instructions. Leave a little extra cable at each fixture in case you have to adjust their location. 14 Complete...
Safety and compliance information for Spotlight Cam Pro (2nd Gen)
...must disconnect the power source at the home’s circuit breaker or consumer unit and test that the power is off BEFORE removing an existing light fixture, installing the device, or touching electrical wires. It is extremely important to adhere to this safety precaution, especially if any natural...
Installing your Hardwired Kit for Spotlight Cam (1st Gen), Wired
...If you’d like other lights (such as floodlights) use the red wire to wire it to the auxiliary light fixtures in accordance with this diagram: Your connected lights also turn on when you manually enable your Spotlight Cam Wired lights in the Ring app...
Installing Flo by Moen
...off valve and pressure reducing valve. The Smart Water Shutoff should be installed before the plumbing system branches off into the different fixtures in the home. Note: DO NOT install the Flo by Moen Smart Water Shutoff on fire sprinkler or suppression systems and hot water distribution lines...
Safety and compliance information for Ring Floodlight Cam Pro (2nd Gen)
...Verify that the supply voltage is correct. Connect fixture to a 100 VAC~240 VAC 50/60 Hz power source. You must ensure that you correctly identify Line, Neutral and Earth feeds from the home, and that...