Search Results
Showing results for adhesive
Install and use your Ring Alarm Panic Button
...Keep the Panic Button out of the reach of small children and pets. Follow these steps to physically install your Panic Button: Pre-attached adhesive Clean the mounting location. Peel the rubber pads off of the bottom cover to expose the adhesive tape. Press the Panic Button firmly to the...
Install No-Drill Mount for battery doorbells
...mounting bracket 1. Choose a smooth, even mounting surface, and wipe it clean. Do not install on glass. 2. Remove the protective strips from the adhesive tape. 3. Hold the mount against the mounting surface for five minutes and allow an hour for it to adhere. 4...
Replacing the cable on your Door View Cam
...or tube). Remove the adhesive The replacement cable will have an adhesive strip that is used to attach it to the tube. Peel the backing off the adhesive strip and attach the cable to the tube in the same location you removed the old cable. Plug in the new cable With the old cable removed, plug the...
Installing No-Drill Mount (2nd Gen) for Battery Video Doorbell (2nd Gen) devices
...Installation with a Wedge or Corner Kit 1. Choose a smooth, even mounting surface, and wipe it clean. 2. Remove the protective strips from the adhesive tape. 3. Hold the mount against the mounting surface for five minutes and allow an hour for it to adhere...
Safety and compliance information for No-Drill Mount
...Flip the pull-tabs up. 3. Remove No-Drill Mount. While firmly holding the mount, gently pull up on the adhesive strips until the mount releases from the wall. 34 32 Retrait 1. Retirer les vis de sécurité. 2. Retourner les languettes vers le haut. 3. Retirer...
Positioning Alarm Contact Sensors on different types of doors, windows and trim
...to lever the back of the magnet component of the Contact Sensor. Remove the slim magnet. Install the slim magnet next to the sensor, using the adhesive pad. Window or door that is not flush with the frame or moulding Make sure that the Contact Sensor and magnet are less than 2.5 cm apart...
Installing your Contact Sensor (2nd Generation)
...Remove the slim magnet. Install the slim magnet next to the sensor, using the adhesive pad. Using a Ring Alarm Contact Sensor Riser If you are still having a problem getting your Contact Sensor positioned correctly, a Ring Alarm...
Installing and using Ring Alarm Contact Sensor
...Gen) Confirm the backplate is connected to the Sensor. Make sure that the mounting surface is clean and dry before peeling the backing off of the adhesive strip. Install the sensor and magnet on a door or window frame by making the alignment lines parallel to each other and pressing it into place...
Ring device manuals
...dragflikarna. / Käännä vetokielekkeet alaspäin. / Vip begge tapper ned. / 両方のタブ を下方向に向けます。 3. Firmly hold the mount and gently pull down on both adhesive strips until the mount releases from the wall. / Tenez fermement le support et tirez doucement sur les deux bandes adhésives jusqu’à ce que le...
Setting up and using your Ring Alarm Motion Detector
...mounting bracket onto the back of the Motion Detector. Ensure the mounting surface is clean and dry before peeling the backing off of the adhesive strip...