Search Results
Showing results for extremo-holes
Search instead for extreme-holes
Solar Panels for battery doorbells
...wood using the provided screws. If you are mounting to brick, concrete or stucco: Mark the holes where you wish to mount the Solar Panel. Drill holes for the anchors. Insert the anchors. Use the screws to secure the mount...
Safety and compliance information for Ring Floodlight Cam Wired Plus
...Disassembly guide for recycling Wrik de vergrendeling eruit met een platte schroevendraaier. 10 Pull the driver power wires out of the threading holes. Retirez le câble d'alimentation du moteur des trous filetés. Ziehen Sie das Kabel aus dem Gewindeloch heraus. Estrai il cavo di alimentazione del...
Installing Floodlight Cam Wired Plus and Pro
...mounting plate as a template. Then, use a 6mm masonry drill bit (not included) to drill holes in the wall, and insert the included anchors. 7. Install the mounting plate Run the wires through the hole in the mounting plate. Install the mounting plate with the two posts level with the ground...
Installing Ring Alarm at your business
...used to gain access to your business. If installing Contact Sensors on warehouse doors or metal door and window casings, you may need to pre-drill holes and get special screws designed for this type of installation...
Installing Wired Video Doorbell Elite (2nd Gen)
...can be installed on a flat surface or directly over existing wiring. 2. Use the surface mount as a guide to mark screw holes on the wall. 3. Route the wiring through the center hole, ensuring cables are not pinched or kinked. 4. Install the surface mount with the included screws. On stucco, brick...
Installing a Solar Panel with your security camera
...or stucco, use a 6 mm drill bit to drill holes where you marked the position of the mounting holes, and put the included plastic anchors into the holes. You might need to use a hammer to secure the anchors...
Installing Wired Video Doorbell Plus (2nd Gen) Hardwired
...On stucco, brick, or concrete, use a 6 mm (1/4 in) masonry bit to drill holes for the included wall anchors. (Optional) If using a wedge mount, install the mount over your doorbell wires using the screws included with your...
Installing your Indoor Cam (2nd Gen)
...Slide down to unhook and remove the mounting plate. Install the mounting plate. On stucco, brick, or concrete, use a 6 mm masonry bit to drill holes for the included wall anchors. Slide onto mounting plate. Adjust the camera angle. Using the privacy cover. Removing the privacy cover. Attaching...
Ring Alarm (2nd Generation) Installation Guide
...the mounting bracket at the mounting location and level it using the spirit level. Mark your holes using the mounting bracket as a guide. Drill holes using a 6mm drill bit. Adjust the tamper arm screw to ensure that the arm makes contact with the mounting surface...
Installing and using Ring Alarm Glass Break Sensor
...sensor. Use it to mark where you plan to drill holes on the mounting surface. Use a 5 mm drill bit to pre-drill holes. Push the anchors into the holes. Use a Phillips head screwdriver and included screws to attach the mounting bracket to the wall or ceiling. Attach the sensor by placing it on the...