Search Results
Showing results for extreme-holes
Installing your Hardwired Kit for Spotlight Cam Wired/Mount
...If you haven’t already, push your power cable into the box through the grommet you cut. Drive two of the included Mounting Screws through the holes on either side of the backbox to secure it. Note: If installing on a hard surface like brick or stucco, pre-drill these holes with the included...
Installing a Solar Panel with your security camera
...or stucco, use a 6 mm drill bit to drill holes where you marked the position of the mounting holes, and put the included plastic anchors into the holes. You might need to use a hammer to secure the anchors...
Using a Wedge Kit or Corner Kit with your doorbell
...surface Installing on a wood surface Drills and wall anchors are not needed. Installing on a masonry surface Using the marked screw hole locations, drill pilot holes using a 1/4” or 6mm drill bit. Insert the included wall anchors...
Safety and compliance information for Ring Wired Video Doorbell Pro (3rd Gen)
...Read all safety instructions for any accessories before using with your device. Don’t expose your device to steam, extreme heat or cold. Use your device in a location where temperatures remain within the device’s operating temperature range set forth in this guide...
Replacing the cable on your Door View Cam
...replace the cable, you will need to uninstall your Door View Cam, including the battery and tightening nut from the indoor assembly and the door hole adapter (if installed). Get instructions on uninstalling your Door View Cam. Unplug the old cable On the outdoor assembly, grasp the small tab...
How to physically install your Ring Video Doorbell 3 without an existing doorbell
...of the mounting holes. If you are mounting the Ring Video Doorbell 3 on brick, concrete, or stucco, put the included plastic anchors into the holes. You may need to use a hammer to get the anchors in. If you are using the included optional adaptor mounting plate on wood or vinyl, just use the...
Installing Wired Video Doorbell Pro (3rd Gen) PoE
...7/8 in) in diameter. NOTE : Exercise caution for electrical wiring and pipes when drilling. 4. Route the USB-C cable into the wall and through the hole. 5...
Installing Doorbell Retrofit Kit
...If you’ve accidentally poked incorrect holes, seal them with the included rubber plugs. 5. (Optional) Prime or paint your kit to match your home before installation. 6. Attach the retrofit...
Safety and compliance information for Ring Outdoor Cam Pro
...For best performance, we recommend pairing the adapter with an ethernet cable that is rated for outdoor use. Do not expose your adapter to steam, extreme heat or cold. Use your adapter in a location where temperatures remain within the adapter’s operating temperature range set forth in this guide...
Safety and Compliance Information for Outdoor Cam Plus
...or the third-party accessory. Read all safety instructions for any accessories before using with your device. Don’t expose your device to steam, extreme heat or cold. Use your device in a location where temperatures remain within the device’s operating temperature range set forth in this guide...