Search Results
Showing results for screws
Uninstalling your Door View Cam
...sure what will be compatible. Once that's done, place the flat edge of the Door View Key into the slots on your peephole and rotate clockwise to screw it in. If you don’t have the Door View Key, you can use a large flathead screwdriver or another flat tool...
Troubleshooting Ring Outdoor Siren
...tightly or is not mounted correctly. Check the following: Tighten the tamper arm screw on the Outdoor Siren mounting bracket so that it makes contact with the mounting surface. Make sure the mounting screws are fully tightened and the Outdoor Siren is secured on the mounting bracket. If your...
Installing Hardwired Kit for Outdoor Cam Pro and Spotlight Cam Pro (2nd Gen)
...use a 1/4 in (6 mm) masonry bit to drill holes for the included wall anchors. 6. Cover screws with rubber caps. Optional: Use the built-in hooks to hold the S-hook. 7. Connect wires. Fasten earth screw with a minimum torque of 0.4N/m...
Installing your Stick Up Cam Battery (2nd Gen)
...screws. Attach the battery cover Line up the "open lock" symbol on the rear of your Stick Up Cam with the line on the battery cover. Push the cover on and twist clockwise to lock into place. Tighten the screw Use the star-shaped end of your Ring screwdriver to tighten the security screw on...
Floodlight Cam Installation Guide
...Align the mounting posts with the holes on Floodlight Cam and press together, securing the screw cap nuts with the orange Ring screwdriver handle. 11. Restore power After restoring power, the lights will turn on and your Floodlight Cam will...
Installing Doorbell Retrofit Kit
...Remove your existing doorbell or intercom, if necessary. NOTE: Keep the screws safe for now. 3. Use the guide to identify holes D and remove the correct plugs. 4. (Optional) Prime or paint your kit to match your home before...
Installing Wired Video Doorbell Elite (2nd Gen)
...over existing wiring. 2. Use the surface mount as a guide to mark screw holes on the wall. 3. Route the wiring through the center hole, ensuring cables are not pinched or kinked. 4. Install the surface mount with the included screws. On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to...
How to physically install your Ring Video Doorbell 3 without an existing doorbell
...faceplates on your Ring Video Doorbell by slotting it in at the top and clicking it into place. 7. Tighten the security screw Use one of the provided security screws and the star-shaped end of the screwdriver bit to secure the faceplate. Click here for information on setting up your Ring...
Installing Wedge Kit for Wired Video Doorbell Pro (3rd Gen)
...the wedge mount as a guide to mark screw holes on the wall, if necessary. NOTE: Mark the both top holes or both bottom holes, depending on your desired installation location. 3. Install the mount over your doorbell wires or on the wall with the included screws, ensuring it is facing down. On...
Installing your hardwired transformer kit
...For ease of installation, unclamp the clips that have no wires connected to them. Remove the cover from your home doorbell. Loosen the terminal screw for the wire labeled Front. Open the orange lever on the wire clip and insert this wire, snapping the orange lever down to secure the wire. The...