Search Results
Showing results for holes-from'
Installing Battery Doorbell Pro (2nd Gen)
...4 ft (1.20 m) Battery Doorbell Pro | 4EN 3. (Optional) If using a corner mount, install the mount on the mounting surface using the bottom holes in the top and bottom sections, ensuring it is facing in your desired viewing direction. On stucco, brick, or concrete, use a 6 mm (1/4 in...
Installing Battery Video Doorbell Plus (2nd Generation)
...as a guide to mark screw holes on the wall. 3. (Optional) If using a corner mount, install the mount on the mounting surface using the bottom holes in the top and bottom sections, ensuring it is facing in your desired viewing direction. On stucco, brick, or concrete, use a 1/4 in (6 mm...
Hardwiring your battery-powered Ring doorbell
...doorbell. Installing on a wood surface Drill and wall anchors are not needed. Installing on a masonry surface Using the marked screw hole locations, drill pilot holes using a 6 mm drill bit. Insert the included wall anchors...
Installing Floodlight Cam Wired Pro (2nd Gen)
...2. On stucco, brick, or concrete, use a 6 mm masonry bit to drill holes for the included wall anchors. Floodlight Cam Pro (2nd Gen) | 7EN 3. Feed the wires through the mounting plate. 4. Install the mounting plate with...
Installing Doorbell Retrofit Kit
...If you’ve accidentally poked incorrect holes, seal them with the included rubber plugs. 5. (Optional) Prime or paint your kit to match your home before installation. 6. Attach the retrofit...
Installing Solar Panel for Battery Doorbells
...kit, install a wedge or corner kit with its included screws and route the power cable through the center hole. On stucco, brick, or concrete, use a ¼ in (6 mm) masonry bit to drill holes for the included wall anchors. 3. Feed the power cable through the doorbell spacer, then secure it in place...
Safety and compliance information for Ring Keypad (1st Generation)
...bracket on the wall, then use the wall anchors and screws from your kit to fasten the bracket to the wall (If using anchors, you should pre-drill holes). 2. Slide the Keypad onto the bracket. Screws: 3x 3x21mm. Anchors: 3x 5mm. Declaration of Conformity Hereby, Ring LLC, declares that the radio...
Installing PoE+ Adapter with Mount
...holes with the included plugs. 4. Disassemble the cable gland by unscrewing the cap from the body. 5. Thread the Ethernet cable through the cable gland, wrapping the O-ring around the cable, and screw tightly until there is a secure seal. NOTE: If the Ethernet cable is routed through the centre hole...
Installing Spotlight Cam Plus or Pro
...on a wood surface : Screw the plate directly into the wall. If installing on a masonry (concrete, brick, or stucco) surface: Mark four screw holes using the plate as a guide. Drill pilot holes using a 6 mm drill bit. Insert the included wall anchors, then drive the four mounting screws...
Installing and using Ring Alarm Keypad
...Keypad, use the bracket to mark the drill holes. If installing on drywall: Use a 5 mm drill bit to pre-drill holes, then push the anchors into the holes. Use a Phillips-head screwdriver and the included screws to attach the mounting bracket to the wall...