Search Results
Showing results for holes
Ring Alarm (1st Generation) Installation Guide
...If using anchors, you should pre-drill holes.) 3. Slide the Keypad onto the bracket. 7. Learn to use Ring Alarm Alarm Modes: Your Alarm system has three Security Modes to choose from...
Installing lens cover for Outdoor Cam Pro
...to detach the camera mount. 3. Remove the top rubber cap on the back of your camera. NOTE : Store the rubber cap in a safe place. Reinsert when the hole is not in use. 4. Place your lens cover on your camera in the open position. NOTE : Unplug your power cable, if necessary. 5. Tighten the screw...
Install No-Drill Mount for battery doorbells
...it to adhere. 4. Attach the Wedge or Corner Kit using the two included bracket screws. If installing on a Wedge Kit, insert a screw into a threaded hole on either side of the bottom opening. For best results, only use one Wedge or Corner Kit. 5. Attach the mounting bracket using the four included...
Installing Outdoor Cam Pro Plug-In
...12. Secure the power adapter with the included anchors and screws. On stucco, brick, or concrete, use a 5 mm masonry bit to drill holes for the included wall anchors. Ceiling installation 1. Slide the mounting plate in the direction opposite to the UP arrow to remove. 2. Use the...
Floodlight Cam Installation Guide
...Cam from the bracket while connecting the wires. Hook one end of the provided hook into one of the mounting holes on your Floodlight Cam. Hook the other end into the small hole on the bracket...
Installing your Hardwired Kit for Spotlight Cam Wired/Mount
...If you haven’t already, push your power cable into the box through the grommet you cut. Drive two of the included Mounting Screws through the holes on either side of the backbox to secure it. Note: If installing on a hard surface like brick or stucco, pre-drill these holes with the included...
Installing Wired Video Doorbell Plus (2nd Gen)
...On stucco, brick, or concrete, use a 6 mm (1/4 in) masonry bit to drill holes for the included wall anchors. (Optional) If using a wedge mount, install the mount over your doorbell wires using the screws included with your...
Install and use your Ring Alarm Panic Button
...so the unlock symbol is aligned with the indicator. Pull to separate, then set the Panic Button aside. If installing on drywall, drill pilot holes in the mounting surface using a 5 mm drill bit. Insert the wall anchors. Position the back cover over the anchors and screw it into place. Place...
How to completely reset your Alarm devices
...If not already done, remove the device from its mounting bracket. On the back of the device, using a paperclip (or similar) press and hold the pin hole button. Continue holding the button for ~10s watching the LED blink rapidly blue...
Installing and using Ring Alarm Keypad
...Keypad, use the bracket to mark the drill holes. If installing on drywall: Use a 5 mm drill bit to pre-drill holes, then push the anchors into the holes. Use a Phillips-head screwdriver and the included screws to attach the mounting bracket to the wall...