Search Results
Showing results for pairing
Install and use your Ring Alarm Range Extender
...plug: 89.6X47X29.4mm Excluding notch and plug: 81X47X29.4mm ButtonAction button 4 ColorEventBehavior Blue In Pairing ModeLong Blink pattern repeated indefinitely or until paired Paired successfullyLED Off Device powers on (and enters inclusion mode) Long Blink pattern repeated indefinitely or...
Ring Alarm Keypad (2nd Generation) lights and buttons explained
...battery power. Below you'll find descriptions and explanations for each button and light on the Keypad. Network light - Only lights up during pairing or to indicate errors. If it's red, there is a network communication failure. Battery light - Indicates battery status...
How to make your Ring Alarm ignore certain sensors
...You’ve pulled the tab on a security device that has been paired to your Alarm Base Station, but haven’t yet finished setting up the device. You are updating your compatible Alarm sensor firmware and need to...
Creating and managing Access Codes for Alarm users
...access code for the Alarm Owner: Set up your Alarm Base Station . Connect your Keypad to your Base Station by plugging it in and waiting for it to pair. Learn more about setting up your Alarm Keypad When prompted, create and confirm a four-digit owner access code. You will need to enter the code...
Installing your Hardwired Kit for Spotlight Cam Wired/Mount
...Pull up the orange tabs on the wire clip to open. Line up the ends of each pair of wires side-by-side, and fully insert them into the holes in the clip. Then, just push the orange tabs down to close and secure the connection...
Ring Alarm Base Station setup troubleshooting
...We can’t find your Base Station." You will see this message if your Base Station can’t pair with your Ring app. Recommended steps: Check that your Base Station is plugged in. If it’s not, find an outlet and plug it in. If you’ve confirmed...
Installing Video Doorbell Pro Retrofit Kit
...the four pins on the back of the kit are flush against the mounting holes. Note: If the kit will not sit flush against the wall, you can use a pair of pliers to remove one or more of the pins that are preventing it from lying flat. Use the longer screws included in the packaging to secure the...
Safety and compliance information for Ring Outdoor Cam Pro
...For best performance, we recommend pairing the adapter with an ethernet cable that is rated for outdoor use. Do not expose your adapter to steam, extreme heat or cold. Use your adapter in...
Ring Alarm Z-Wave technical information
...plug: 89.6X47X29.4mm Excluding notch and plug: 81X47X29.4mm ButtonAction button 4 ColorEventBehavior Blue In Pairing ModeLong Blink pattern repeated indefinitely or until paired Paired successfullyLED Off Device powers on (and enters inclusion mode) Long Blink pattern repeated indefinitely or...