Search Results
Showing results for extreme-holes
Installing and using Ring Alarm Keypad
...Keypad, use the bracket to mark the drill holes. If installing on drywall: Use a 5 mm drill bit to pre-drill holes, then push the anchors into the holes. Use a Phillips-head screwdriver and the included screws to attach the mounting bracket to the wall...
Lithium-ion battery safety
...lithium-ion battery can fail due to the following: Overcharging: an overcharged battery can rupture, overheat, catch fire, or explode. Extreme temperatures: extreme cold and heat can affect battery charging. Keep batteries in moderate temperature conditions. Impacts: impacts that cause dents or...
Setting up and installing your Ring Alarm Base Station
...Choose a central location. This improves Z-Wave network coverage in all directions. Don’t use the Base Station outdoors or in an environment with extreme temperatures or humidity. Don’t use the Base Station near corrosive chemicals...
Installing Wedge Kit for Wired Video Doorbell Pro (3rd Gen)
...Use the wedge mount as a guide to mark screw holes on the wall, if necessary. NOTE: Mark the both top holes or both bottom holes, depending on your desired installation location. 3. Install the mount over your doorbell wires or on the wall with the included screws, ensuring...
Installing and using Ring Alarm Outdoor Siren
...1: Install the mounting bracket Hold the mounting bracket at the intended installation location and level it using the bubble level. Mark your holes using the mounting bracket as a guide. Leave 2.5 cm of space around all sides for easy removal and replacement. Step 2: Drill holes Drill holes...
Installing lens cover for Outdoor Cam Pro
...to detach the camera mount. 3. Remove the top rubber cap on the back of your camera. NOTE : Store the rubber cap in a safe place. Reinsert when the hole is not in use. 4. Place your lens cover on your camera in the open position. NOTE : Unplug your power cable, if necessary. 5. Tighten the screw...
Installing Intercom Kit for Video Doorbells
...2. Remove your existing intercom. Refer to your existing intercom’s manual for uninstall instructions or consult a qualified electrician. 3. Poke holes compatible with your video doorbell...
Setting up and using your Ring Alarm Motion Detector
...Don’t use it outdoors or in environments with extreme hot or cold temperatures Don’t aim at heaters, furnaces, and air vents. Don’t aim Motion Detectors towards windows Don't position the Motion...
Installing Spotlight Cam (2nd Generation)
...or concrete, use a 1/4 in (6 mm) masonry bit to drill holes for the included wall anchors. 2. Use the mounting plate as a guide to mark screw holes on the wall with 5.5 in (14 cm) of space in every direction. 5.5 in (14 cm) 5.5 in (14 cm) 5.5 in (14 cm) 5...
Installing your Wired Video Doorbell Pro (formerly Video Doorbell Pro 2)
...improve motion detection and provide a better view. To skip this step, click here (set anchor) To install the Corner Mount: 1. Mark two mounting holes on your wall through the slots on your Corner Mount (fig 1) If you are replacing a Ring doorbell, align the two small screw holes with two of the...