Installing your Spotlight Cam Pro Plug-In

View/download PDF manual (English, Français, Deutsch, Italiano, Español, Nederlands, Svenska, Dansk, Suomi, Norsk)

This article outlines the step-by-step process to install your Spotlight Cam Pro Plug-In. Before you begin installing your Spotlight Cam Pro, make sure you’re following safety code standards.

Quick Start

1. Download and open the Ring app.

2. Select Set Up a Device.

3. Scan QR code with the Ring app.

Hardware included

  • Mounting screws
  • Mounting anchors
  • Cable clips
  • Wall anchors

Tools needed

  • Phillips-head screwdriver
  • Drill (optional)

Remove protective film from device. This ensures your device works properly.

Choose a location with the view you want.

Your camera can be mounted on an outdoor wall, eave, or overhang. Make sure your camera is positioned close enough to an outlet for the length of the included power cable.

If installing on a wall:

Your camera comes ready to mount, with the ball joint pointing down. No adjustments are needed.

Wall.PNG

If installing on an eave or overhang:

Remove the battery compartment cover by twisting it counter-clockwise and insert the ball joint plate with the ball joint pointing up.

Overhang.PNG

Remove the mounting plate.

Slide it down to remove it from the camera mount.

blobid35.png

Install the mounting plate.

For wall installation, the UP arrow should point up. For an eave or overhang, the arrow should point toward the area you want to monitor for motion.

If installing on a wood surface, screw the plate directly into the wall.

If installing on a masonry surface, mark four screw holes using the plate as a guide. Drill pilot holes using a 6mm masonry drill bit. Insert the included wall anchors, then drive the four mounting screws through the mounting plate into the wall anchors.

WARNING! Only use the included mounting screws when securing the mounting plate.

CAUTION! DO NOT drill into your home’s electrical wiring.

Up_arrow.PNG

Attach the camera mount.

Slide it onto the mounting plate.

blobid36.png

Then, tighten the security screw.

blobid37.png

Plug the power adapter into your camera.

Insert the USB-C end of the power adapter into the back of your camera.

Adapter.PNG

Attach your camera to the camera mount.

Loosen the metal collar on the camera mount using a Phillips-head screwdriver (not included). Push the ball joint into the socket until it snaps into place.

blobid38.png

Turn on your camera.

Plug the power adapter into a power outlet.

Adjust the camera angle.

Rotate the camera to focus on the area of your choice. Look at Live View in the Ring app to make sure it’s positioned at your desired angle.

Angle.PNG

Tighten the security screws.

Tighten the security screw on the metal collar to secure the camera position.

Screw.PNG

Then, tighten the security screw on the bottom of your camera to secure the battery compartment.

Battery.PNG

Secure the power cable.

Use the provided cable clips to secure the cable on your wall.

Use a 6mm masonry drill bit to pre-drill holes in the wall and insert the provided anchors first if installing on a masonry surface, like stucco or brick.

Cable.PNG

The power cable can be painted to match your wall.

Secure the adapter.

Secure the power adapter to the wall with the included mounting screws.

Power_adapter.PNG

Last updated 1 month ago