Installing your Video Doorbell Elite

Before setting up your Video Doorbell Elite in the Ring app, you will need to install Video Doorbell Elite in your wall:

1. Connect the Video Doorbell Elite Power Kit

First, install the Video Doorbell Elite Power Kit
The Video Doorbell Elite Power Kit is a PoE (or "Power over Ethernet") injector that takes Ethernet input and outputs it as power over Ethernet to your Video Doorbell Elite.
Click here for more details on installing the Video Doorbell Elite Power Kit.

Using the provided adapter, plug your Video Doorbell Elite Power Kit into any wall socket near your Ethernet source.

Plug the 90 centimetre Ethernet cable into the port that says "Internet In."
This cable will run from either your router or Ethernet switch.
Plug the 15 metre cable into the port that says, "To Ring Elite."
Run this cable to Video Doorbell Elite, going through your walls, if necessary. You are now ready to install your doorbell.

2. Install the mounting bracket in your wall (optional)

If you don't have a junction box in your wall, install the mounting bracket that came with your Video Doorbell Elite, which also serves as a junction box.
If you already have an existing junction box, then you can simply discard the mounting bracket.
To install the mounting bracket:
- When you turn the screws, you might notice the wing clamps turning, which will secure the bracket inside your wall.
Trace the enclosed mounting bracket template onto your wall.
Carefully cut a hole in your wall.
Fit the mounting bracket inside and tighten the two install screws.

3. Run the Ethernet cable

Turn off the power at the source.
Pull the Ethernet cable through the hole.
If you plan on connecting Video Doorbell Elite to an existing doorbell, pull the wires through, as well.
Plug the Ethernet cable into the Ethernet port on the back of Video Doorbell Elite.
You'll hear a "click" to confirm it's secure.
The ring on the front of Video Doorbell Elite will start spinning and you'll hear that it's in setup mode. If this doesn't happen, check to make sure your connections to the Video Doorbell Elite Power Kit are secure.
If you are connecting to existing doorbell wires, first shut off power at the main breaker. Then, insert the doorbell wires into the small wire connectors next to the Ethernet port.
It doesn't matter which wire goes into which hole.
Using the included flathead screwdriver, tighten the two small screws to securely connect your doorbell wires.
Restore power at the breaker.

4. Secure the Video Doorbell Elite in the bracket

Insert Video Doorbell Elite into the bracket by angling the top towards you and sliding it into the bracket.
Use both thumbs to press around Video Doorbell Elite simultaneously.
Don't be afraid to use some pressure, since it could be a tight fit.
Tighten the top and bottom screws to secure your Video Doorbell Elite .

5. Set up your Video Doorbell Elite in the Ring app

Note: Be sure to set up your Video Doorbell Elite in the Ring app before installing the faceplate.

In the Ring app, select
Set Up a Device
Follow the in-app instructions to connect Video Doorbell Elite to your wifi network.

6. Secure faceplate to Video Doorbell Elite

After setup, snap your desired faceplate over your Video Doorbell Elite.
Use the flexible screwdriver included in your kit to secure the faceplate by turning the security screw at the bottom of your doorbell.

Your Video Doorbell Elite is now ready for use.

Last updated 9 months ago

English (GB)Change

Ring Help Home