Search Results
Showing results for -install
Physically installing your Stick Up Cam Elite
...Simply scroll down for a step-by-step guide or watch this video. Note that you should set up your Stick Up Cam in the Ring app before physically installing it. Click here for instructions on setting up your Stick Up Cam Elite in the Ring app. 1. Slide off the bottom cover The first step in...
Installing Outdoor Cam Pro PoE
...Install the included junction box on the wall or ceiling with the included screws. On stucco, brick, or concrete, use a 5 mm masonry bit to drill holes...
Installing Outdoor Cam Plus Battery
...Learn how to install Outdoor Cam Plus for battery use by following these steps. Note: Outdoor Cam Plus has a larger mounting plate than previous Outdoor Cams or Stick Up Cams. Mounting plates from other cameras cannot be used when installing Outdoor Cam Plus. Outdoor Cam Plus...
Installing Wired Video Doorbell Pro (3rd Gen)
...Install the included transformer. (Optional) Remove the transformer from its housing unit. 8. Connect power to the bottom L & N terminals and the doorbell to positive & negative terminals (doorbell wires can go in either terminal). 9. (Optional) If using a corner mount, install the mount...
Installing your Hardwired Kit for Spotlight Cam
...3. Cut the grommet The included backbox has two cable inlets with rubber grommets. Choose the inlet that suits your install location, then get out the scissors. Cut off the end of the grommet cone at a point where it’s a bit narrower than your cable. If you’re routing...
Installing Doorbell Retrofit Kit
...be working with electrical wires during the install process. If you encounter damaged or unsafe wiring, or if you are unsure, uncomfortable, or inexperienced, please consult with a licensed electrician. For Australian and New Zealand Customers Installation and wiring must be performed by a licensed...
Installing DIN Rail Transformer (3rd Gen)
...Türklingel, um die Einrichtung abzuschließen. Follow these step-by-step instructions to install your DIN Rail Transformer (3rd Gen). Hardware Included Tools Needed Phillips-head screwdriver Installation 1. Shut off power at the breaker. NOTE: If you are unsure which breaker to flip, turn off...
Installing Wired Video Doorbell Pro (3rd Gen) PoE
...hole. 5. (Optional) If connecting to an in-home chime, route the doorbell wiring through the hole. 6. (Optional) If installing your doorbell without a wedge or corner kit, install the spacer over the USB-C cable and wiring with the included screws. On stucco, brick, or concrete, use a 6 mm (1/4...
Installing Solar Charger (USB-C) for Battery Doorbells
...0.25 in (6 mm) masonry bit to drill holes for the included wall anchors. 4. Optional: Install a wedge or corner kit using its included screws. 5. Install your doorbell’s mounting bracket. 6...
Installing Wedge Kit for Wired Video Doorbell Plus (2nd Gen)
...to your doorbell setup guide to prepare your install location. 2. Use the wedge mount as a guide to mark screw holes on the wall, if necessary. NOTE: Mark the both top holes or both bottom holes, depending on your desired installation location. 3. Install the mount over your doorbell wires or on the...