Search Results
Showing results for push
Set up and install Ring Intercom
...For the hidden tab: Place the screwdriver on the tab. Push down on the screwdriver to remove faceplate. For the pull off: Insert flat-head screwdriver. Twist and pry off the front cover using the...
Configuring and troubleshooting your in-home chime
...Tap Ring my In-home Chime to hear your in-home chime ring when the doorbell is pressed. Follow the in-app instructions and push the button on your Ring doorbell. If it does not ring correctly, select either My chime rang partially or My chime didn’t ring . The Ring app will...
Creating a routine with Alexa and your Ring device
...tap Smart Home to select a Ring camera to record 1 , tap Announcement to enter an announcement message or tap Send push notification to receive a push notification when the device is triggered. Tap Next...
Installing your Hardwired Kit for Spotlight Cam
...If you’re routing the cable through the rear, insert it now. 4. Prepare the backbox If you haven’t already, push your power cable into the box through the grommet you cut. Drive two of the included Mounting Screws through the holes on either side of the...
Installing Spotlight Cam (2nd Generation)
...Insert the battery and twist to close the battery cover to the locked position. 4. Discard the battery insulator and fully charge the battery. 3. Push the tab to remove the battery. 6. Tighten the security screw on the battery cover. CAUTION! The security screw creates a seal to prevent damage...
Installing your Stick Up Cam Battery (2nd Gen)
...Installing Stick Up Cam on a wall or ceiling If you're mounting Stick Up Cam on a wall: Push the rubber pad into the top of the base. Flip the base toward the rear. If you're mounting Stick Up Cam on a ceiling: Swivel the base above the...
Fixing offline devices
...Look at the Device Health section in the Ring app. This will show the current status of your device. Check for notifications. You may receive a push notification, text message or email alerting you that your device is offline. Reconnecting your device If your device is offline, try these steps...
Physically installing your Stick Up Cam Elite
...The base of the stand is hinged. Before wall-mounting, flip the base down and behind your Stick Up Cam. 3. Push the rubber pad back into the base. The rubber pad should sit between your wall and the base of your Stick Up Cam. 4. Drive the screws. Hold the...
Installing Stick Up Cam Pro
...If using a Plug-In Adapter or a Solar Panel, plug the cable into the back of the Stick Up Cam Pro. Using the Plug-In Adapter outdoors Press the “PUSH” button and slide the outdoor plug off of the adapter. Then, slide its connector onto the power adapter until it clicks into place. Step 9: Secure...
Ring Spotlight Cam Battery Installation
...the battery compartment on your Spotlight Cam. Push the battery into the compartment until it clicks into place. Firmly close the battery compartment door Note: It may take a bit of pressure to completely close the compartment door. Be sure to push on it until you hear the click that indicates...