Search Results
Showing results for i-seconds
Chime, Chime Plus and Chime Pro setup guide
...If the light is flashing, tap The light is flashing If the light is not flashing, press and hold the button on the side of the chime for five seconds. Have your wifi password ready to enter. When prompted, join the Ring wifi network. Connect with Bluetooth for Chime (3rd Gen) and Chime Plus...
Fixing offline devices
...If charging doesn't resolve this, hold the front doorbell button as you factory reset your doorbell for 30 seconds while not connected to the charger. Your doorbell should turn back on after completing these steps. Factory reset or power cycle your Ring device...
Understanding Indoor Cam and Pan-Tilt Indoor Cam light patterns
...device setup issues. Blue light flashing four times quickly, then stopping for half of a second. Factory reset is complete Blue light flashing quickly for five seconds, then staying solid for five seconds. Factory reset is complete Red light flashing quickly for five seconds, then the device...
Charging your Ring Video Doorbell
...or cover back on the device until it clicks, and then reinsert the security screws. Wait for the device to power back on : It can take up to 60 seconds. Screw use warning. When securing your Ring device with the security screw(s), only use the small star-shaped screws that came with your device...
Safety and compliance information for Ring Stick Up Cam Plug-In
...2402 - 2480 MHz: 8.93 dBm EIRP * Ring Stick Up Cam Plug-In enters Networked Standby approximately 30 seconds after a video event has finished recording. Power Consumption Your Ring device uses an external power supply. View energy efficiency information...
Ring Video Doorbell Pro setup mode
...up and flash and your doorbell has power, you can try performing a hard reset. To perform a hard reset: Hold down the right button for a full 30 seconds. After releasing it, the light should flash a few times, indicating that your Video Doorbell Pro is restarting. Allow a minute for this process...
Safety and compliance information for Ring Indoor Cam (1st Gen)
...in Watts) Networked Standby* 1.01 * The device automatically goes into networked standby after 8 seconds of inactivity Your Ring device uses an external power supply. View energy efficiency information related to the external power supply...
Fixing audio and video issues
...internet speeds. Learn more about wifi recommendations for Ring devices . Restart your phone or tablet: Turn off your phone or tablet for 30 seconds, then turn it back on. Virtual private network (VPN): Turn off any virtual private networks on your phone or tablet. Update the Ring app: Make...
Request access with Amazon Key Access (for visitors)
...and request access. How to request access via Amazon Key Access Unlock your mobile device and hold it near the Amazon Key Access panel for a few seconds. Search the resident directory by name or unit number. If the person you’re trying to reach isn’t listed, contact them directly. Tap the phone...
Rebooting your Ring Video Doorbell or Security Camera
...instructions and tips to help get your device back online. Then follow the steps above to reboot in the Ring app. Take the battery out for a few seconds. Some Ring devices have a Quick Release Battery Pack that you can slide out to temporarily disconnect power to the device. The device will reboot...