Installing the Ring Plug-In Adapter for wired doorbells

The Plug-In Adapter can be used when there is no existing doorbell wiring or the existing system is unusable.

Purchase a Plug-In Adapter for your doorbell.

Installing your Plug-In Adapter

1. Choose an outlet.

• Select a power outlet near the door where you plan to install your doorbell. 
  • Don't plug the power adapter in yet!

2. Run the cable.

• Run the cable down from the outlet to your molding and then choose a path to your doorbell.
• Secure the cable to the wall with the provided cable clips.
  • The cable can be run through your walls, or through a door or window if desired.
  • Always be careful of existing electrical wiring and pipes when drilling through walls.

3. Attach the wires.

• Attach the power cables to the terminals on the rear of your doorbell.

4. Install and set up your doorbell.

• Get instructions for installing your doorbell

  .
• Get instructions for setting up your doorbell in the Ring app

  .

5. Set "Doorbell Type" to "None" in the Ring app.

• In the Ring app, select your doorbell, then tap the gear icon and select

  Doorbell Kit Settings

  .
• Select

  None

  and

  Save

  your settings.
  • Do not skip this step or your Ring doorbell may be damaged.

6. Plug in the Plug-In Adapter.

• The front light on your Ring doorbell should illuminate to indicate that it's powered properly.
• If your doorbell has never been set up, the front light will blink, indicating that your Ring has entered

  Setup Mode.

7. Test your doorbell.

• Push the button on the front of your Ring Doorbell to try it out.