Search Results for Ring Help
Showing results for facilities-hole'
Installing Intercom Kit for Video Doorbells
...2. Remove your existing intercom. Refer to your existing intercom’s manual for uninstall instructions or consult a qualified electrician. 3. Poke holes compatible with your doorbell...
Installing Wired Doorbell Plus (2nd Gen) Hardwired
...large oval holes, ensuring it is facing in your desired viewing direction. On stucco, brick, or concrete, use a 6 mm (1/4 in) masonry bit to drill holes for the included wall anchors. (Optional) If using a wedge mount, install the mount over your doorbell wires using the screws included with your...
Installing Stick Up Cam Pro
...into the wall. If installing on a masonry (concrete, brick, or stucco) surface, mark four screw holes using the plate as a guide. Drill pilot holes using a 0.24 in (6 mm) drill bit. Insert the included wall anchors, then drive the four mounting screws through the mounting plate into the wall...
Installing Wired Doorbell Pro (3rd Gen) Hardwired
...Re-attach your chime’s cover. 8. (Optional) If using a corner mount, install the mount over your doorbell wires using the bottom holes in the top and bottom sections, ensuring it is facing in your desired viewing direction. On stucco, brick, or concrete, use a 6 mm (1/4 in...
Installing Outdoor Cam
...If installing on a masonry (concrete, brick, or stucco) surface, mark four screw holes using the plate as a guide. Drill pilot holes using a 0.24 in (6 mm) drill bit. Insert the included wall anchors, then drive the four mounting screws through the mounting plate into the wall...
Installing Wired Doorbell Plus
...wall first. If you used the wire nuts, push them through the hole as well. Once you’re done, skip ahead to page 18. DO NOT USE any screw other than the included 1" mounting screws when securing your Ring Doorbell. Mark the screw holes. Using your Ring Doorbell as a template, mark the location of...
Learn About Super Solar Panel for Outdoor Cam and Spotlight Cam
...the provided screws and screwdriver. If you are mounting to brick, concrete, or stucco, do the following: Mark the holes where you wish to mount your Super Solar Panel. Drill a hole for the anchors using the provided drill bit. Insert the anchors...
Installing Access Controller Pro
...Drill pilot holes (use anchors if needed). Insert mounting screws into device housing. Align device with pilot holes. Secure device with power drill. If you are using anchors, insert them into the wall. Installing with 3M sticky tape or Velcro Step 5: Setting up...
Installing Indoor Cam Plus
...on the wall. 3. Install the mounting plate with the UP arrow pointing up. On stucco, brick, or concrete, use a 3/16 in (5 mm) masonry bit to drill holes for the included wall anchors. Indoor Cam Plus | 5EN 4. Plug the power cable into your camera. 5. Swivel your camera’s mount toward the back. 6...
Installing PoE+ Adapter with Mount
...holes with the included plugs. 4. Disassemble the cable gland by unscrewing the cap from the body. 5. Thread the Ethernet cable through the cable gland, wrapping the O-ring around the cable, and screw tightly until there is a secure seal. NOTE: If the Ethernet cable is routed through the center hole...