Search Results for Ring Help
Showing results for tape
Installing No-Drill Mount for Ring battery doorbells
...bracket 1. Choose a smooth, even mounting surface, and wipe it clean. Do not install on glass. 2. Remove the protective strips from the adhesive tape. 3. Hold the mount against the mounting surface for five minutes and allow an hour for it to adhere. 4...
Installing No-Drill Mount (2nd Gen) for Battery Doorbell (2nd Gen) devices
...with a Wedge or Corner Kit 1. Choose a smooth, even mounting surface, and wipe it clean. 2. Remove the protective strips from the adhesive tape. 3. Hold the mount against the mounting surface for five minutes and allow an hour for it to adhere. 4. Attach the Wedge or Corner Kit using the...
Access Controller Pro 2
...Ring Access Controller Pro v2 Device 8 pin screw type plug-in connector USB 5V DC wall supply Micro USB cable Cable labels Double sided mounting tape Puck Antenna Installation guide Installation Tools Required Professional installation highly recommended • Wires (18-22 AWG)/ Cables for connector...
ProductInstalling and using Ring Alarm Glass Break Sensor
...Use the included mounting tape, clean the area, then peel off the backing. Press the sensor to the wall and hold for 20 seconds to make sure the tape is securely attached. • Ceiling. Use the included screws and anchors. First remove the back cover and set the sensor aside. Screw the back cover to...
Ring Alarm Z-Wave Technical Information
...Page 2 of 6 Installation 1. Securely mount the Ring Retrofit Alarm Kit to the wall near the wired alarm panel by using the pre-applied double stick tape on the back of the device or with screws by removing the top cover and inserting the screws through the mounting holes on either side of the device...
Installing Wired Doorbell Pro (3rd Gen)
...Trans wires with a wire nut. 5. Use the included wire nuts to connect each wire with the included Chime Kit Mini’s wires. 6. Peel the double-sided tape backing on the Chime Kit Mini and hold it against the wall for 30 seconds in your desired install position. 7...
Ring Retrofit Alarm Kit FAQs
...20 or 22 gauge wire, wire nuts or wire connectors, and a cleaning cloth and alcohol to clean the wall before installing using the provided mounting tape. If you would prefer to screw the Retrofit Alarm Kit into your wall, you’ll need to two screws and anchors for your wall and a drill bit. What do...
Installing Access Controller Pro
...Align device with pilot holes. Secure device with power drill. If you are using anchors, insert them into the wall. Installing with 3M sticky tape or Velcro Step 5: Setting up and activating Ring Access Controller Pro 2 Once your Access Controller Pro is installed, you will need to use the...
Installing and using Ring Alarm Contact Sensor
...Button on the front to help with easy troubleshooting. Green LED light for softer light at night. Mounting tape included on the back of the sensor. Uses two CR 2032 coin cell batteries (included). Setting up your Contact Sensor Before installing your Contact...
Installing Wired Doorbell Plus (2nd Gen)
...Trans wires with a wire nut. 5. Use the included wire nuts to connect each wire with the included Chime Kit Mini’s wires. 6. Peel the double-sided tape backing on the Chime Kit Mini and hold it against the wall for 30 seconds in your desired install position...