Search Results for Ring Help
Showing results for facilities-hole'
Safety and compliance information for Spotlight Cam Pro (2nd Gen)
...the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure, provided repair facilities and parts for the goods are available. Subject to any rights that you may have under the Australian Consumer Law, you may be required to bear...
Installing lens cover for Outdoor Cam Pro
...2EN 4. Place your lens cover on your camera in the open position. NOTE: Unplug your power cable, if necessary. 5. Tighten the screw into the top hole on the back of your camera to secure. 6. Attach the mount to the bottom of your camera with its screw. 7. Reattach the mounting plate by sliding...
Safety and Compliance for Battery Doorbell (2nd Gen)
...the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure, provided repair facilities and parts for the goods are available. Subject to any rights that you may have under the Australian Consumer Law, you may be required to bear...
Installing Wedge Kit for Wired Doorbell Pro (3rd Gen)
...install location. 2. Use the wedge mount as a guide to mark screw holes on the wall, if necessary. NOTE: Mark the both top holes or both bottom holes, depending on your desired installation location. 3. Install the mount over your doorbell wires or on the wall with the included screws, ensuring...
Installing Wedge Kit for Wired Doorbell Plus (2nd Gen)
...Use the wedge mount as a guide to mark screw holes on the wall, if necessary. NOTE: Mark the both top holes or both bottom holes, depending on your desired installation location. 3. Install the mount over your doorbell wires or on the wall with the included screws, ensuring...
Installing Wired Doorbell Plus Retrofit Kit
...Uninstall your existing Ring Video Doorbell. Place the Retrofit Kit on the mounting holes that were used for your previous Ring Video Doorbell installation. Place the Ring Wired Doorbell Plus over the Retrofit Kit. Make sure that the...
Installing Pan-Tilt Indoor Cam
...the hole in the mounting bracket and plug in. Secure your camera to the mounting bracket by sliding until you feel a click. Secure your camera and bracket to the mounting plate by sliding until you feel a click. Ceiling installation Use the mounting plate as a guide to mark screw holes on the...
Solar Panel for Stick Up Cam Battery (2nd Gen) Information
...the provided screws and screwdriver. If you are mounting to brick, concrete, or stucco, do the following: Mark the holes where you wish to mount your Ring Solar Panel. Drill a hole for the anchors using the provided drill bit. Insert the anchors. Use the screws to secure the mount. How do I aim...
Installing No-Drill Mount for Ring battery doorbells
...it to adhere. 4. Attach the Wedge or Corner Kit using the two included bracket screws. If installing on a Wedge Kit, insert a screw into a threaded hole on either side of the bottom opening. For best results, only use one Wedge or Corner Kit. 5. Remove your doorbell’s faceplate. 6. Attach your...
Installing Outdoor Cam Pro Plug-In
...12. Secure the power adapter with the included anchors and screws. On stucco, brick, or concrete, use a 3/16 in (5 mm) masonry bit to drill holes for the included wall anchors. Ceiling installation 1. Slide the mounting plate in the direction opposite to the UP arrow to remove. 2. Use the...