Ring Doorbell Flashing Light Patterns Guide
Learn about light patterns for Video Doorbells.
The light patterns below are for the following devices:
- Video Doorbell (1st and 2nd Gen)
- Video Doorbell 2, 3, 3 Plus, and 4
- Battery Doorbell, Battery Doorbell Plus, and Battery Doorbell Pro.
- Video Doorbell Wired
- Peephole Cam (Door View Cam)
Activity | Flashing Light Pattern |
|---|---|
Connecting to Network During Setup | Blue light moving upward |
Indicates Percentage of Charge (applicable for Video Doorbell 2nd Gens) | Blue light incrementally cycling around |
Setup Mode | Spinning white - times out after 10 minutes |
Successful Setup | Four blue LED's flash four times |
Failed Setup: Ring Temporary Network Access Point The Ring Network is for setup only. When you complete setup you'll connect to your home wifi network and won't be connected to the Ring Network. | White light flashing on the right |
Failed Setup: Incorrect Password Passwords are case sensitive and have no spaces. | White light flashing on the top |
Failed Setup: No internet access, communication blocked Make sure you're able to access websites using the same wifi. Alternatively, the network configuration may need to be adjusted to allow Ring to complete setup. | White light flashing left for 3 minutes |
Firmware Update Doorbell is updating internally. | White light flashing on and off |
Idle Mode Doorbell is idle. This mode only applies when your doorbell is wired to your home electricity. | Solid white light |
Boot (Power Up) | Blue flashing - 1 second on, 1 second off |
Wifi Connected This will only show right after successfully setting up to wifi | Blue flashing - 4 corner LEDs flash 4 times |
Factory Reset | Blue flashing for 5 seconds, then white spinning (setup mode) |
Low Power (applies for Wired Doorbell Plus, Pro, and Video Doorbell Wired) | Blue flashing for 5 seconds, then white spinning (setup mode) |
Last updated 2 months ago