Connecting your Super Solar Panel to your Outdoor Cam

Physically installing and connecting your Super Solar Panel to your Outdoor Cam (formerly Stick Up Cam (3rd Gen)) is a simple process. Simply scroll down for a step-by-step guide.

Note: Outdoor Cam Pro is not compatible with Super Solar Panel.

Note: You should complete the setup of your Outdoor Cam (formerly Stick Up Cam (3rd Gen)) in your Ring app before installing the Super Solar Panel.

Tap here for information on setting up your Stick Up Cam in the Ring app.

Step One: Select your install location

When selecting your installation spot, be sure to choose a spot that gets reliable solar exposure every day. The Super Solar Panel can keep your Outdoor Cam (formerly Stick Up Cam (3rd Gen)) charged with just a few hours of direct sunlight per day.

Step Two: Line up your Super Solar Panel

• Using the Solar Panel mounting arm as a template, mark the screw holes on your chosen surface with a pencil.

Step Three: Drill Holes

• Optional: Use a drill to drill holes where you marked the position of the mounting holes.
• If you are mounting the Super Solar Panel on brick, concrete, or stucco, put the included plastic anchors into the holes. You may need to use a hammer to get the anchors in.
• If you are mounting the bracket on wood or vinyl, do not drill, just use the included screws.

Step Three: Put up the mounting arm  

• Secure the mounting arm to the wall with the included screws. Tighten until snug.

Step Four: Put up the Super Solar Panel

• Slide the solar panel onto the mounting arm. Make sure it's seated securely.

Note: If you'd like to adjust the angle of the solar panel for better solar coverage, loosen the adjustment screw on the mounting arm, set your desired angle, then re-tighten the screw.

Step Five: Pop out the weatherproofing plug on your Outdoor Cam (formerly Stick Up Cam (3rd Gen))

• Remove the rubber plug from the rear of your Ring device.
• Plug your Super Solar Panel into your Ring device.

Step Six: Plug the Super Solar Panel charging cable into the Outdoor Cam (formerly Stick Up Cam (3rd Gen))

• Route the charging cable from your Super Solar Panel into the power connector on your Ring device.
• Plug the snap ring barrel charging cable into the power connector on your Ring device.

Step Seven: Mount the Outdoor Cam (formerly Stick Up Cam (3rd Gen))

• Attach your Ring device to the base if you removed it during installation.

Note: Make sure to charge and insert the included battery into your Outdoor Cam (formerly Stick Up Cam (3rd Gen)). Super Solar Panel keeps your battery charged but does not replace it.