Search Results
Showing results for resistor
Hardwiring your Ring Video Doorbell
...our other Video Doorbells. You may need to consult a qualified electrician. Connecting your Ring Video Doorbell directly to an AC transformer Resistor required? Pro Power Kit required...
Device compatibility list
...Doorbell Wired Battery Video Doorbell Battery Video Doorbell Plus Battery Video Doorbell Plus (2nd Gen) Battery Video Doorbell Pro Wirewound Resistor Video Doorbell (1st Gen) Video Doorbell 2 Power over Ethernet Adapter (2nd Gen) Stick Up Cam Elite Video Doorbell Elite PoE+ Adapter with Mount...
Important information on upgrading to a Ring Video Doorbell 3 or Ring Video Doorbell 3 Plus
...Video Doorbell 3 Plus. Leaving the diode in may cause your new doorbell to behave erratically. You should also remove any existing resistors when upgrading. Resistors are not needed when hardwiring a Ring Video Doorbell 3 or Ring Video Doorbell 3 Plus...
Connect your Video Doorbell (2nd Generation) to a low-voltage transformer with no doorbell
...2Vdc, 100mA or 109mA) - Solar Panel (5Vdc, 380mA/480mA/800mA) Using incompatible power sources can damage your device and cause electric shock A resistor is not required. Do not install a diode, as the in-home chime functionality is now controlled via the Ring app. WARNING : Electrical shock hazard...
Video Doorbell (1st Gen)
...Spare Parts (mounting plates, screws, charging cables, etc.) • Wedge Kit • Corner Kit • Plug-In Adapter (2nd Generation) • Wirewound Resistor • Intercom Kit Software Security System Requirements...
ProductVideo Doorbell 2
...level, charging cable, etc.) • Wedge Kit • Corner Kit • Quick Release Battery Pack • Solar Panel • Plug-In Adapter (2nd Generation) • Wirewound Resistor • Intercom Kit • Interchangeable Faceplate Software Security System Requirements...
ProductHardwiring your battery-powered Ring doorbell
...battery doorbells do not need any changes to the wiring. For Video Doorbell 2 and Video Doorbell (1st Gen) you will need to install a Wirewound Resistor. Step 4: Preparing the mounting position If using a Wedge Kit, Corner Kit , or mounting bracket with your device, install before mounting the...
Ring device manuals
...which wire connects to which screw. The wiring must be connected to a transformer with a voltage of 8VAC – 24VAC and an internal doorbell or resistor. DC transformers and most intercoms are not supported. If wiring to an existing doorbell... 1312 If you have a digital doorbell, connecting the...
How to physically install your Ring Video Doorbell 3 without an existing doorbell
...8–24 volt AC vid 50 eller 60 Hz, max 40 VA. Om du ansluter direkt till en dörrklockstransformator ska du använda en 25 ohm, 50 W kabelansluten resistor i serie med en av dörrklockskablarna för att skydda Video-dörrklockan...