Search Results
Showing results for attach
Install No-Drill Mount for battery doorbells
...protective strips from the adhesive tape. 3. Hold the mount against the mounting surface for five minutes and allow an hour for it to adhere. 4. Attach the Wedge or Corner Kit using the two included bracket screws. If installing on a Wedge Kit, insert a screw into a threaded hole on either side of...
Installing Doorbell Retrofit Kit
...If the retrofit kit starts to flex, the screws are too tight. 7. Clip on the retrofit cover to attach. 8. (Optional) If using a wedge or corner mount, install the mount over the retrofit kit. 9. Attach the doorbell bracket over the mount or retrofit kit. 10. Refer to your doorbell setup guide to...
Installing lens cover for Outdoor Cam Pro
...Attach the screw cap to the bottom of your camera. 7. Attach the camera mount to the back of your camera with its screw. 8. Reattach the mounting plate by sliding until you hear a click to secure. 9. Refer to your camera setup guide to attach your camera to the wall...
Installing No-Drill Mount (2nd Gen) for Battery Video Doorbell (2nd Gen) devices
...Attach your doorbell’s mounting bracket using the two included mounting screws. 7. Hook your doorbell over the mounting bracket to attach. 8. Refer to your doorbell setup guide to reattach the faceplate and secure your...
Installing Outdoor Cam Pro PoE
...bit to drill holes for the included wall anchors. Unscrew to detach the camera mount. Remove the middle rubber cap on the back of your camera. Attach the camera mount to the back of your camera with its screw. Plug the included USB-C cable into your camera until the indicator line disappears...
Installing Pole and Wall Mount for Cameras and Solar Panels
...the rubber cap on the back of your security camera and use it to plug the bottom. 6. Attach the security camera mount to the back of your security camera with its screw. 7. Clasp the security camera mount and attach your security camera to the mounting plate by sliding until you feel a click. 8...
Outdoor Siren power sources
...you begin, make sure the battery cover is off. When you finish connecting your power sources, replace the back cover and tighten the screws. Then attach the Outdoor Siren to the mounting bracket. Tighten the security screw on the bottom of the bracket. Use these directions for each power source...
Ring Pole Mount Installation Guide
...the Pole Mount for Spotlight Cam Battery and Stick Up Cam. 1. For Solar Panel Attach the Ring Solar Panel (not included). For Super Solar Panel Attach the Ring Super Solar Panel (not included). If not using the Solar Panel, place the pole cap over the opening. 2. For Spotlight Cam Remove the...
Floodlight Cam Installation Guide
...floodlight A) With power off at the fuse box, remove your existing floodlight from the wall and disconnect the wires. B) If there is a bracket attached to the wall, remove that as well. 4. Install the mounting bracket Cut a hole in the gasket to fit your wires, and run them through. Install the...
Ring Spotlight Cam Battery Installation
...Do not use any other screws to secure the plug. Attach Spotlight Cam to the mounting bracket: First, fully loosen the metal collar on the bracket using the phillips end of the included screwdriver...