Search Results
Showing results for i-remove
Installing Ring Video Doorbell Wired
...Uninstall your existing doorbell button Once you’ve removed it from your wall, disconnect the wires. Make sure the wires don’t fall back inside your wall, so you can access them later. 8. Remove the faceplate from your Ring Video Doorbell To do this, grasp the bottom of...
Troubleshooting your Ring Intercom devices
...of the handsets by gently tugging on each wire. To exit and restart testing mode: Tap the X in the top right. Tap End Testing. Close the Ring app. Remove and reinsert the battery from your Ring Intercom device...
Installing Outdoor Cam Pro PoE
...Wall installation FOR INDOOR USE ONLY Slide the mounting plate in the direction opposite to the UP arrow to remove. Use the mounting plate as a guide to mark screw holes on the wall with 5.5 in (14 cm) of space in every direction. Install the mounting plate...
Installing Stick Up Cam Pro
...bit (optional) Note: Remove protective film from device. This ensures your device works properly. Step 1: Charging the battery Learn more about charging the Quick Release Battery . Twist the battery compartment counterclockwise to unlock and remove the cover. Then, remove the battery and discard...
Inspecting Door View Cam's flex cable
...of your Door View Cam. Gently grasp the plastic connector on the end of the cable and remove it from the connector port. Note: The cable is fragile, so be careful not to bend it too much or tear it when removing it from the connector port. Inspect the flex cable The following images show the most...
Installing Outdoor Cam Plus Battery
...Tighten the security screw on the battery cover. (Optional) Adjust your camera’s position, then remove the rubber cap at the base of the camera mount and tighten the screw to secure in place. Replace the rubber cap. 11. Adjust your camera’s angle...
Using light settings for Ring security cameras
...Tap Save in the upper right corner. To delete a light schedule: Tap an existing custom schedule, then select Remove this Schedule and tap the Remove schedule button. You can turn a light schedule on or off by tapping the switch next to the desired schedule. Troubleshooting lights for cameras If...
Installing Pole and Wall Mount for Cameras and Solar Panels
...security camera’s native mounting plate in the direction opposite to the UP arrow to remove. 3. Unclasp the security camera mount. 4. Unscrew to detach the security camera mount from the battery cover. 5. Remove the rubber cap on the back of your security camera and use it to plug the bottom. 6...
Troubleshooting Ring Outdoor Siren
...Important! This will reset the device back to the original default settings. To factory reset your Outdoor Siren: Remove the Outdoor Siren from the mounting bracket. Use a pin, paperclip, or SIM card ejector to press and hold the pinhole reset button. Release the...
Using the adapter plate included with your Ring Video Doorbell 2
...1. Remove your original Ring Video Doorbell Once you have removed the original Ring doorbell and mounting plate, place the adapter plate with it's smaller side (or the beveled edge...