Search Results
Showing results for installable
Installing Floodlight Cam Wired Pro (2nd Gen)
...Risk of electrical shock. Disconnect power at the fuse or circuit breaker before installing. CAUTION: Risk of fire. Do not install near combustible or flammable surfaces. Note: Your Floodlight Cam must be installed on a 4 in round UL-listed weatherproof electrical box...
Installing your Door View Cam
...it (if not, skip ahead). Check for paint on or around your peephole, both indoors and outdoors. Use the toothed edge of the included tool to carefully remove paint covering the edges or slots. 3...
Installing Wedge Kit for Wired Video Doorbell Pro (3rd Gen)
...on your desired installation location. 3. Install the mount over your doorbell wires or on the wall with the included screws, ensuring it is facing down. On stucco, brick, or concrete, use a 6 mm masonry bit to drill holes for the included wall anchors. 4. If installing multiple wedge or...
Installing Wired Video Doorbell Plus (2nd Gen)
...Get step-by-step installation instructions for your Wired Video Doorbell Plus (2nd Gen) Installing Wired Video Doorbell Plus (2nd Gen) Hardwired Installing Wired Video Doorbell Plus (2nd Gen) Plug-In...
Installing lens cover for Outdoor Cam Pro
...your camera, slide the lens cover to the locked position until you feel a click. 2. To uncover your camera, slide the lens cover to the unlocked position until you feel a click...
Installing Outdoor Cam Pro
...Get step-by-step installation instructions for your Outdoor Cam Pro. Installing Outdoor Cam Pro Plug-In Installing Outdoor Cam Pro PoE...
Installing Video Doorbell Pro Retrofit Kit
...Uninstall your existing Ring Video Doorbell. Place the Retrofit Kit on the mounting holes that were used for your previous Ring Video Doorbell installation. Place the Ring Video Doorbell Pro over the Retrofit Kit. Make sure that the four pins on the back of the kit are flush against the mounting...
Installing your Hardwired Kit for Spotlight Cam Wired/Mount
...3. Cut the grommet The included backbox has two cable inlets with rubber grommets. Choose the inlet that suits your install location, then get out the scissors. Cut off the end of the grommet cone at a point where it’s a bit narrower than your cable. If you’re routing...
Installing Wedge Kit for Wired Video Doorbell Plus (2nd Gen)
...on your desired installation location. 3. Install the mount over your doorbell wires or on the wall with the included screws, ensuring it is facing down. On stucco, brick, or concrete, use a 6 mm masonry bit to drill holes for the included wall anchors. 4. If installing multiple wedge or...
Ring Alarm (2nd Generation) Installation Guide
...devices. Contact Sensor Contact Sensors can be installed on any door or window. It doesn’t matter which direction or orientation you install them, as long as the Sensor and magnet line up and are no more than 2.5cm (1") apart. We recommend installing Contact Sensors on every door and window that...