Search Results
Showing results for extreme-holes
Install No-Drill Mount for battery doorbells
...it to adhere. 4. Attach the Wedge or Corner Kit using the two included bracket screws. If installing on a Wedge Kit, insert a screw into a threaded hole on either side of the bottom opening. For best results, only use one Wedge or Corner Kit. 5. Attach the mounting bracket using the four included...
Using the adapter plate included with your Ring Video Doorbell 2
...it's smaller side (or the beveled edge) facing the wall. 2. Use the original drill holes You can line up the holes in the adapter plate with the holes left behind from your original Ring mounting bracket. Then use the install screws to attach the adapter plate to the wall...
Installing Ring Video Doorbell Wired
...two mounting holes on your wall. 10. Install the anchors from Bag A (optional) On stucco, brick or concrete, use a 1/4" (6mm) masonry bit to drill holes in your wall, then insert the included wall anchors. Note : If you're installing on wood or siding, you can skip this step. 11. Connect the...
Installing PoE+ Converter Mount
...Slide the mounting plate on your camera’s native mount opposite to the UP arrow to remove. 2. Use the mounting plate to mark screw holes on the wall. 3. Route the Ethernet cable. Routing the cable through the wall: 3a. Feed the Ethernet cable through the included grommet, then the...
Installing Spotlight Cam Pro (2nd Gen) Plug-In
...installation 1. Slide the mounting plate in the direction opposite to the UP arrow to remove. 2. Use the mounting plate as a guide to mark screw holes on the wall with 5.5 in (14 cm) of space in every direction. 3. Install the mounting plate with the UP arrow pointing up. On stucco, brick, or...
Installing Outdoor Cam Plus Plug-In
...installation 1. Slide the mounting plate in the direction opposite to the UP arrow to remove. 2. Use the mounting plate as a guide to mark screw holes on the wall. 3. Install the mounting plate with the UP arrow pointing up. On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to drill...
Installing Floodlight Cam Wired Pro (2nd Gen)
...2. On stucco, brick, or concrete, use a 6 mm masonry bit to drill holes for the included wall anchors. Floodlight Cam Pro (2nd Gen) | 7EN 3. Feed the wires through the mounting plate. 4. Install the mounting plate with...
How to install your Ring Video Doorbell Pro with a hardwired transformer
...a conventional doorbell. 3.1 Uninstall your existing doorbell Unscrew your existing doorbell from the wall and disconnect its wires. 3.2 Mark the holes Using your Ring Doorbell as a template, mark the location of the two mounting holes on your wall. 3.3 Removing the faceplate To access the...
Installing Outdoor Cam
...into the wall. If installing on a masonry (concrete, brick, or stucco) surface, mark four screw holes using the plate as a guide. Drill pilot holes using a 0.24 in (6 mm) drill bit. Insert the included wall anchors, then drive the four mounting screws through the mounting plate into the wall...
Safety and compliance information for Ring Intercom Video
...Read all safety instructions for any accessories before using with your device. Don’t expose your device to steam, extreme heat or cold. Use your device in a location where tempera- tures remain within the device’s operating tempera- ture range set forth in this guide...