Search Results
Showing results for extreme-holes
Ring devices and extreme temperatures
...You may need to bring it inside to charge it with a USB cable, instead of waiting for it to solar charge. Hot weather Extreme temperatures and other conditions can cause your Ring video doorbell or security camera to overheat. Some devices will enter Device Cooldown to...
Safety and compliance information for Ring Keypad (1st Generation)
...bracket on the wall, then use the wall anchors and screws from your kit to fasten the bracket to the wall (If using anchors, you should pre-drill holes). 2. Slide the Keypad onto the bracket. Screws: 3x 3x21mm. Anchors: 3x 5mm. Declaration of Conformity Hereby, Ring LLC, declares that the radio...
Installing your Indoor Cam (2nd Gen)
...السريعة على جهازك. 3. Choose a location. / Ring Indoor Cam and its accessories are for indoor use only. Don’t expose your device to steam, extreme heat or cold...
Safety and compliance information for Indoor/Outdoor Power Adaptor
...à micro-ondes ou un sèche-cheveux Pour éviter tout risque d’électrocution, ne touchez pas votre appareil ou les fils connectés à celui-ci pendant un orage lorsqu’il est branché Pour plus d’informations sur la compatibilité des appareils, reportez-vous à la...
Install and use your Ring Alarm Panic Button
...so the unlock symbol is aligned with the indicator. Pull to separate, then set the Panic Button aside. If installing on drywall, drill pilot holes in the mounting surface using a 5 mm drill bit. Insert the wall anchors. Position the back cover over the anchors and screw it into place. Place...
Safety and compliance information for Ring Door View Cam
...Read all safety instructions for any accessories before using with your device. Don’t expose your device to steam, extreme heat or cold. Use your device in a location where temperatures remain within the device’s operating temperature range set forth in this guide...
Installing Wired Video Doorbell Elite (2nd Gen)
...can be installed on a flat surface or directly over existing wiring. 2. Use the surface mount as a guide to mark screw holes on the wall. 3. Route the wiring through the center hole, ensuring cables are not pinched or kinked. 4. Install the surface mount with the included screws. On stucco, brick...
Safety and compliance information for Access Control Unit V2
...or the third-party accessory. Read all safety instructions for any accessories before using with your device. Don't expose your device to steam, extreme heat or cold...
Hardwiring your battery-powered Ring doorbell
...doorbell. Installing on a wood surface Drill and wall anchors are not needed. Installing on a masonry surface Using the marked screw hole locations, drill pilot holes using a 6 mm drill bit. Insert the included wall anchors...
Installing No-Drill Mount (2nd Gen) for Battery Video Doorbell (2nd Gen) devices
...Attach the Wedge or Corner Kit using the two included bracket screws. Important note : If installing on a Wedge Kit, insert screw into a threaded hole on either side of the bottom opening. For best results, only use one Wedge or Corner Kit. 5. If your doorbell has a faceplate, use the removal tool...