Search Results
Showing results for extremo-holes
Search instead for extreme-holes
Installing PoE+ Adapter with Mount
...disparaisse. / Collegare l’altra estremità del cavo USB-C all’alimentatore fino a quando la linea dell’indicatore non scompare. / Conecta el otro extremo del cable USB-C al adaptador, introduciéndolo hasta que desaparezca la línea del indicador. / Sluit het andere uiteinde van de USB-C-kabel aan op...
Using the adapter plate included with your Ring Video Doorbell 2
...it's smaller side (or the beveled edge) facing the wall. 2. Use the original drill holes You can line up the holes in the adapter plate with the holes left behind from your original Ring mounting bracket. Then use the install screws to attach the adapter plate to the wall...
Install and use your Ring Alarm Panic Button
...so the unlock symbol is aligned with the indicator. Pull to separate, then set the Panic Button aside. If installing on drywall, drill pilot holes in the mounting surface using a 5 mm drill bit. Insert the wall anchors. Position the back cover over the anchors and screw it into place. Place...
Ring device manuals
...luces para que no bloqueen la cámara y, a continuación, gira la cámara hacia la derecha. 8. Quita la funda precortada del cable para exponer el extremo del cable y usa las tuercas para cables, incluidas con la cámara, para conectar los cables verde (tierra), blanco (neutro) y negro (fase) a los...
Installing No-Drill Mount (2nd Gen) for Battery Video Doorbell (2nd Gen) devices
...Attach the Wedge or Corner Kit using the two included bracket screws. Important note : If installing on a Wedge Kit, insert screw into a threaded hole on either side of the bottom opening. For best results, only use one Wedge or Corner Kit. 5. If your doorbell has a faceplate, use the removal tool...
Installing lens cover for Outdoor Cam Pro
...to detach the camera mount. 3. Remove the top rubber cap on the back of your camera. NOTE : Store the rubber cap in a safe place. Reinsert when the hole is not in use. 4. Place your lens cover on your camera in the open position. NOTE : Unplug your power cable, if necessary. 5. Tighten the screw...
Installing Pole and Wall Mount for Cameras and Solar Panels
...Una volta che l’estremità della fascetta raggiunge il lato del supporto, inserirla di nuovo e serrare fino a fissarla completamente. / Cuando el extremo de la abrazadera llegue al lateral del soporte, vuelve a insertarla y apriétala hasta que quede totalmente fijada. / Zodra het uiteinde van de...
Installing your Wired Video Doorbell Pro (formerly Video Doorbell Pro 2)
...improve motion detection and provide a better view. To skip this step, click here (set anchor) To install the Corner Mount: 1. Mark two mounting holes on your wall through the slots on your Corner Mount (fig 1) If you are replacing a Ring doorbell, align the two small screw holes with two of the...
Solar Chargers for battery doorbells
...a battery. Key features Weather resistant Can be mounted directly into wood using included hardware Can be mounted using existing doorbell drill holes No in-app setup required Compatibility and installation Your Ring Solar Charger uses either a USB-C connector or a fork connector cable, depending...
Floodlight Cam Installation Guide
...Cam from the bracket while connecting the wires. Hook one end of the provided hook into one of the mounting holes on your Floodlight Cam. Hook the other end into the small hole on the bracket...