Ring Alarm Glass Break Sensor - Setup and use

Ring Alarm Glass Break Sensor is designed to monitor glass windows or doors for break in attempts. When armed, the Glass Break Sensor will trigger your Ring Alarm when breaking glass is detected. You can customise which Alarm Modes the Glass Break Sensor will actively detect breaking glass.

Glass Break Sensor features

• Alerts and history:

  Get Ring app alerts when breaking glass is detected and review detection history in the app.
• Alarm modes:

  By default, the Glass Break Sensor detects breaking glass in Home and Away Mode but does not detect in Disarmed Mode. You can

  adjust these settings through the app

  .

Additional Glass Break Sensor specifications

• Uses 3 AA batteries.
• Mount on the wall, ceiling or shelf within 7.5 metres of glass. Actual range and performance can vary due to usage, environment and other factors.
• Requires the Ring Alarm.
• Uses Z-Wave to communicate with the Base Station.

Where should I install Glass Break Sensors?

• Mount the Glass Break Sensor at least 2 metres off the ground and within 7.5 metres of any glass windows or doors inside your home. You may also choose to mount it on the ceiling or place the device on a shelf.
• Use the included screws and anchors when mounting on the ceiling or a rough surface.
• Avoid placing on surfaces such as tables or shelves where items are frequently set down and picked up.
• Rooms with multiple glass windows and doors.
• Basements with glass windows or doors with outside access.

Is there anywhere I should avoid using a Glass Break Sensor?

• Avoid using inside detached garages, warehouses, or sheds because Z-Wave devices may not reach that far.
• Avoid placing on surfaces such as tables or shelves where items are frequently set down and picked up.

Glass Break Sensor setup

How to setup and install a Glass Break Sensor:

1. Make sure your Ring Alarm is disarmed.
2. In the Ring app, open the menu. Tap

   Set Up a Device

   , then tap

   Security.

   Tap

   Sensors

   and find the

   Glass Break Sensor

   .
3. Follow the in-app instructions to complete setup.
4. Mount the sensor at least 2 metres off the ground and within 7.5 metres of any glass windows or doors inside your home.
   • The Glass Break Sensor can be placed on a shelf or attached to a wall or ceiling.
   • Avoid placing on surfaces such as tables or shelves where items are frequently set down and picked up.
   • Use the included screws and anchors when mounting on the ceiling or a rough surface.
5. If using mounting tape, ensure the mounting surface is clean and dry before peeling the backing off of the adhesive strip.
   • Firmly press and hold the Glass Break Sensor in place for 20 seconds to ensure it is securely attached.
6. If using the included screws (3x21mm) and anchors (5x25mm), use a 5mm drill bit to pre-drill holes. Push the anchors in and then use a Philips #2 screwdriver to screw the mounting bracket to the wall or ceiling.

How do I replace my Glass Break Sensor’s batteries?

1. To open, twist off the back cover.
2. Replace the old batteries with new AA alkaline batteries.
3. Make sure that the batteries are inserted correctly. When inserting batteries, take care to match + and - symbols with the markings on your sensor.
4. Close the cover by twisting until the lock arrow points towards the lock symbol.

WARNING: Inserting a battery the wrong way could damage the device. Make sure that the + and - symbols on the battery align properly.