Search Results
Showing results for mount
Outdoor Cam Pro
...Outdoor Cam Pro • Camera mount • Installation tools and screws • Security sticker • PoE+ Adapter and mount Compatible Accessories • 18W Indoor/Outdoor USB-C Power Adapter • PoE+ Adapter with Mount • Hardwired Kit for Outdoor Cam Pro and Spotlight Cam Pro (2nd Gen) Software Security Updates System...
ProductInstalling your Stick Up Cam Battery (2nd Gen)
...on a wall: Push the rubber pad into the top of the base. Flip the base toward the rear. If you're mounting Stick Up Cam on a ceiling: Swivel the base above the camera. Make sure the camera is mounted right side up. You will not be able to change upside-down videos in the Ring app. Push the rubber...
Installing your Indoor Cam (1st Gen)
...on the bracket pointing upwards. Remove the mounting bracket Slide it down. It’ll come right off the base. Drive the screws Hold the plate against your wall, making sure the “UP” arrow is pointing up, and mount it with the included screws. Mount your Cam Guide the grooves in the base onto the...
Installing Floodlight Cam Wired Pro (2nd Gen)
...7. Use the nylon strap on the back of your camera fixture to hook it onto the mounting plate. NOTE : Ensure the buckle and hook are secure before releasing. 8. Connect the wires from your camera to the terminal block. NOTE : Gently...
How to physically install your Ring Video Doorbell 3 without an existing doorbell
...mounting holes with a pencil. 3. Drill holes Optional: Use a drill to drill holes where you marked the position of the mounting holes. If you are mounting the Ring Video Doorbell 3 on brick, concrete, or stucco, put the included plastic anchors into the holes. You may need to use a hammer to get the...
Installing Wired Video Doorbell Pro (3rd Gen) PoE
...holes in the top and bottom sections, ensuring it is facing in your desired viewing direction. (Optional) If using a wedge mount, install the mount over the USB-C cable using the screws included with your wedge kit, ensuring it is facing down. On stucco, brick, or concrete, use a 6 mm (1/4 in...
How to install your Ring Video Doorbell Pro with a hardwired transformer
...your doorbell wires are too short, use the wire extenders and wire nuts to extend them. 3.6 Mount your Ring doorbell Feed the wiring back into the wall, and mount your doorbell with the included mounting screws. 3.7 Restore power at the breaker You’re almost there! After turning power back on, it...
Installing Spotlight Cam Pro (2nd Gen) Plug-In
...direction. 3. Install the mounting plate with the UP arrow pointing up. On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to drill holes for the included wall anchors. 4. Remove the middle rubber cap on the back of your camera. 5. Attach the camera mount to the back of your camera...
Installing Outdoor Cam Pro PoE
...Slide the mounting plate in the direction opposite to the UP arrow to remove. Unscrew to detach the camera mount. Remove the middle rubber cap on the back of your camera. Tighten the included hex joint onto the...
Solar Panel (Barrel Connector) for Spotlight Cam and Stick Up Cam Battery
...Panel can be mounted anywhere on a wall or a roof, but should be placed in an area that gets at least a few hours of sun each day. When mounting the Solar Panel, be sure to look out for overhanging branches or the shadows of nearby branches that may block the sun. How do I mount the Solar Panel...